Brinkmann Pro Series 2500 owner manual Install door bracket using four

Page 24

Note: When performing Step 8, Lift grill body from front and rear panels to avoid injury to hands and fingers.

Step 8

With the help of a friend, place grill body assembly on grill cart. Grill body will rest on upper side sections of cart. Align bolt holes located on the outside of the grill body assembly. Secure using four M6 X12mm bolts. At this point, fully tighten four bolts holding back panel from Step 6.

Note: To install battery, unscrew igniter button cap. Insert battery with positive end towards button. Replace igniter button cap.

Step 9

Install door bracket using four

M6 X 12mm bolts. Make sure door stop is set toward back of cart.

23

Grill Body

GRILL LIGHTING INSTRUCTIONS:

 

 

 

 

1.

Read and follow all warnings and instructions

5.

Press the electronic igniter and hold for 3-5

7.

Repeat Steps 4-6 for lighting each burner. Always

 

in owner’s manual before lighting.

 

seconds to light burner.

 

use electronic igniter for lighting each burner.

2.

Open lid before lighting burner.

6.

If burner does NOT ignite immediately, turn control

8.

Refer to owner’s manual for match lighting procedure.

3.

Make sure all control knobs are in the OFF position.

 

knob to OFF, wait 5 minutes to allow gas to

9.

For assistance, call 1-800-527-0717.

4.

Select the burner to be lit. Push and turn the control

 

dissipate and repeat lighting procedure.

10. To turn off, turn control knobs clockwise until it locks

 

knob of that burner to HIGH.

 

 

 

in OFF position.

FOR OUTDOOR USE ONLY

Igniter Button Cap

 

 

 

GRILL LIGHTING INSTRUCTIONS:

 

 

 

 

 

 

 

1.

Read and follow all warnings and instructions

5. Press the electronic igniter and hold for 3-5

7.

Repeat Steps 4-6 for lighting each burner. Always

 

 

 

 

in owner’s manual before lighting.

seconds to light burner.

 

use electronic igniter for lighting each burner.

 

 

 

2.

Open lid before lighting burner.

6. If burner does NOT ignite immediately, turn control

8.

Refer to owner’s manual for match lighting procedure.

3.

Make sure all control knobs are in the OFF position.

knob to OFF, wait 5 minutes to allow gas to

9.

For assistance, call 1-800-527-0717.

4.

Select the burner to be lit. Push and turn the control

dissipate and repeat lighting procedure.

10. To turn off, turn control knobs clockwise until it locks

 

 

OFF

knob of that burner to HIGH.

 

 

in OFF position.

 

 

 

 

OFF

 

OFF

OFF

 

HIGH

HIGH

HIGH

 

HIGH

 

 

LOW

LOW

FOR OUTDOOR USE ONLY

LOW

LOW

 

 

 

 

 

 

 

 

 

 

Door bracket

Image 24
Contents Gas Stainless Steel Outdoor Grill Important Safety For Your SafetyPage Installation Information Cylinder SpecificationsPage Installing the LP GAS Cylinder Onto the Grill Filling the LP GAS CylinderHose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder Leak Testing When to Perform a Leak TestChecking for Leaks PRE-START Check List Lighting Instructions Lighting the Main BurnersMatch Lighting the Main Burners Lighting the Side Burner Match Lighting the Side BurnerTurning OFF the Grill Operating the Grill Breaking in Your GrillPreheating the Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerTransporting and Storage Smoker BOXBefore Storing Your Grill Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCEHardware CastingsTrouble Shooting Problem Possible Causes Burner will not lightCleanliness Grilling to Proper TemperatureHelpful Hints Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts Card Contents Step Step Attach back cart panel by using four M6 X 50mm bolts Install door bracket using four Spring Pin Lower Pivot Screw Holes Procedures. See Grill Bottom Grease Tray Place warming rack in slots above cast iron cooking grills Pro Series 2500 Assembled Accessories Gallon PAN & Basket SET Warranty