Step 12
Remove the plastic cap on gas supply manifold and attach rubber gas hose to gas supply manifold. Hand tighten first, then use supplied wrench to turn brass nut an additional 1/8 turn.
Important: Do not overtighten. This could damage brass fitting.
Warning: Never use your grill without leak testing all gas connections and hoses. See the section on “Leak Testing” in this manual for proper
Gas Hose
Brass Nut
Electrode
procedures. (See page 7)
Step 13
Attach side burner igniter lead to the electrode as illustrated.
Step 14
Attach side table assembly to grill body assembly by inserting four M6 X 20mm bolts halfway into the screw holes of the grill body assembly. Then slide side table assembly onto bolts and secure all four bolts.
Side Burner Igniter
Lead
Side Table
Screw Holes
25