Brinkmann Pro Series 2500 owner manual Spring Pin Lower Pivot Screw Holes

Page 25

Spring Pin

Lower Pivot

Screw Holes

Step 10

Insert right side door over lower pivot (on bottom cart panel) then align door with cart frame. Depress spring pin located on top edge of door and slide door toward side cart panel until spring pin locks into hole in door bracket. Repeat for other door.

Step 11

Attach side burner assembly to grill body assembly by inserting four

M6 X 20mm bolts halfway into the screw holes of the grill body assembly. Then slide side burner assembly onto bolts and secure all four bolts. Install side burner grate and control knob.

Side burner grate

			MAXIMUM SIDE BURNER LOAD = 15 lbs.
	SIDE BURNER LIGHTING INSTRUCTIONS:		6. If burner does NOT ignite immediately, turn control knob to
	1.	Read and follow all warnings and instructions
	1.	Read and follow all warnings and instructions	OFF, wait 5 minutes to allow gas to dissipate and repeat
		in owner’s manual before lighting.	lighting procedure.
	2.	Open lid before lighting side burner.	7. Refer to owner’s manual for match lighting procedure.
	3.	Make sure all control knobs are in the OFF position.	8. For assistance, call 1-800-527-0717.
	4.	Push and turn side burner control knob of that burner to HIGH.	9. To turn off, turn control knob clockwise until it
	5.	Press the electronic igniter and hold for 3-5 seconds	locks in OFF position.
		to light burner.

24

Image 25

Contents Gas Stainless Steel Outdoor Grill For Your Safety Important SafetyPage Cylinder Specifications Installation InformationPage Filling the LP GAS Cylinder Installing the LP GAS Cylinder Onto the GrillHose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder When to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Main Burners Lighting InstructionsMatch Lighting the Main Burners Match Lighting the Side Burner Lighting the Side BurnerTurning OFF the Grill Breaking in Your Grill Operating the GrillPreheating the Grill Controlling FLARE-UPSSide Burner Rotisserie CookingSmoker BOX Transporting and StorageBefore Storing Your Grill Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceHardware CastingsProblem Possible Causes Burner will not light Trouble ShootingGrilling to Proper Temperature CleanlinessHelpful Hints Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts Card Contents Step Step Attach back cart panel by using four M6 X 50mm bolts Install door bracket using four Spring Pin Lower Pivot Screw Holes Procedures. See Grill Bottom Grease Tray Place warming rack in slots above cast iron cooking grills Pro Series 2500 Assembled Accessories Gallon PAN & Basket SET Warranty