Teledyne 3000TA-XL-EU Electrical Connections, Connect primary input power, Install the fuse

Page 7

Model 3000 TA-XL-EU

Quickstart Guide

 

 

Electrical Connections

CAUTION: READ ALL SAFETY INFORMATION REGARDING ELECTRICAL HAZARDS ASSOCIATIED WITH THIS INSTRUMENT BEFORE MAKING ELECTRICAL CONNECTIONS.

CAUTION: POWER IS APPLIED TO THE INSTRUMENT'S CIRCUITRY AS LONG AS THE INSTRUMENT IS CONNECTED TO THE POWER SOURCE. THE RED SWITCH ON THE FRONT PANEL IS FOR SWITCHING POWER ON OR OFF TO THE DISPLAYS AND OUTPUTS ONLY.

•Connect primary input power:

Insert the power cord into the power cord receptacle.

•Install the fuse:

Fuses are not installed at the factory. Be sure to install the proper fuse as part of installation.

Place small screwdriver in notch, and pry cover off, as shown in the figure.

To change between American and European fuses, remove the single retaining screw, flip fuse block over 180 degrees, and replace screw.

Replace fuse as shown below. Reassemble Housing

Teledyne Analytical Instruments

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Model 3000TA-XL-EU Page Front Panel Operator Interface Getting StartedDigital Meter Display Access DoorFunction Keys Data Entry KeysGas Inlet and Outlet One inlet and one exhaust out Rear Panel Equipment InterfaceMake Gas Connections Mount the AnalyzerInstall the fuse Connect primary input powerElectrical Connections 2CXL Micro-fuel Cell Install the Micro-fuel CellInstall 50-Pin Equipment Interface Connector Connect the 9-pin D connector to the RS-232 serial portModel 3000 TA-XL-EU Quickstart Guide Using the Data Entry and Function Buttons Default ConfigurationAuto Ranging on Available Functions Entering the Password Password ProtectionCalibration of the Analyzer Auto Mode Zero CalibrationZero Calibration Auto Mode Spanning Manual Mode ZeroingSpan Calibration Manual Mode Spanning Setting Alarm ParametersSet The Range Function Fixed Range or Autoranging Analysis Analyze Function
Related manuals
Manual 78 pages 19.6 Kb
Top Page Image Contents