Teledyne 3000TA-XL-EU Install the Micro-fuel Cell, Install 50-Pin Equipment Interface Connector

Quickstart Guide Trace Oxygen Analyzer

•Install 50-Pin Equipment Interface Connector

Connect the 50 pin connector to the mating connector on the rear panel.

•Connect the 9-pin D connector to the RS-232 serial port.

See Section 3.3.2.3 in the Instruction Manual for information on setting up serial communication for this instrument.

Install the Micro-fuel Cell

The Model 3000TA-XL-EU can be equipped with either the standard B-2CXL Micro-fuel Cell or as an option, Teledyne’s Insta Trace cell.

B-2CXL Micro-fuel Cell

To install this cell:

1.Remove power to the instrument.

2.Open the front panel door.

3.With one hand placed underneath the cell block ready to catch the Micro-Fuel cell, lift up on the stainless steel gate in front of the cell block. This releases the cell and cell holder from the block. The cell and holder will fall out in your hand.

CAUTION: THE CELL IS SHIPPED SEPARATELY

INSIDE TWO BAGS FILLED WITH

OXYGEN-FREE INERT GAS. USE

CARE TO AVOID EXPOSING THE

CELLTO AIR FOR ANY LONGER THEN

NECESSARY TO INSTALL THE ITEM.

Insta-Trace Micro-fuel Cell

Note: The Insta Trace Micro-fuel Cell has a short recovery time after ambient air exposure, however minimizing this exposure still reduces the recovery time necessary.

CAUTION: DO NOT TOUCH THE SENSING SURFACE OF THE CELL. IT IS COVERED WITH A DELICATE TEFLON MEMBRANE THAT CAN LEAK WHEN PUNCTURED.

Teledyne Analytical Instruments 6