Transport / Storage Requirements

Specifications continued

Dimensions: (without fittings)

Depth:	4.9 in	(12.5 cm)
Width:	2.3 in	(5.7 cm)
Height:	4.1 in	(10.4 cm)
Weight:	2.9 lbs	(1.3 kg)
Shipping Weight:	3.5 lbs	(1.6 kg)
Operating Temperature Range:	59°F to 104°F (15°C to 40°C)

Temperature Range:	-10°F to 140°F (-23°C to 60°C)
Humidity:	Max 95% Noncondensing
FiO2 Accuracy:*	± 3% of full scale @ 50 psi (3.4 bar)
	± 4% of full scale @ 60 psi (4.14 bar)

Pressure Drop:

Low Flow: ≤ 2 psi (0.14 bar) at inlet pressures from 30-90 psi (2.1- 6.2 bar) and at 10 lpm flow rate at 60% FiO2.

High Flow: ≤ 3 psi (0.21 bar) at inlet pressures from 30-90 psi (2.1- 6.2 bar) and at 30 lpm flow rate at 60% FiO2.

The Air-Oxygen Blender has been degreased for Oxygen Service prior to delivery.

The Air-Oxygen Blender reverse gas flow complies with clause 6 of ISO 11195.

The Oxygen Analyzer should comply with ISO 7767 to meet CE requirement.

Dryness and Composition for inlet gases:

Air: Medical Air supply should meet the requirements of ANSI Z86.1 - 1973 commodity specification for Air, type 1 grade D or better.

Oxygen: Oxygen supply must meet all requirements of USP Medical Oxygen Grade N.

Dew Point:

(ONLY for CE requirements)

Both inlets should remain 10°F (5.5°C) or more below the lowest temperature to which the air distribution system equipment is exposed. At a temperature of 25°F (-3.9°C) and a pressure of 90 psi (6.33 kg/cm2) this equates to 2000 mg/m3.

*Accuracy of oxygen concentration will be affected if bleed is not activated at flow settings below 15 lpm for the high flow Blender, and 3 lpm for the low flow Blender.

Specifications are subject to change without prior notice.

Blender

Air-Oxygen