Panasonic CW-XC64HU manual Cabinet Installation

Cabinet Installation

1.Open the window. Mark a line on center of the window sill (or desired air conditioner location).

Carefully place the cabinet on the window sill and align the center mark on the bottom front with the center line marked in the window sill.

(See Fig.1)

2.Pull the bottom window sash down behind the upper guide until it meets.(See Fig.2)

NOTE:

•Do not pull the window sash down so tightly that the movement of Frame Curtain is restricted.

3.Loosely assemble the sill support using the parts in Fig. 3.

4.Select the position that will place the sill support near the outer most point on sill (See Fig. 4)

5.Attach the sill support to the cabinet track hole in relation to the selected position using 2 Type A screws in each support (See Fig. 4).

6.The cabinet should be installed with a very slight tilt (about 12.7mm(1/2")) downward toward the outside (See Fig. 5).

Adjust the bolt and the nut of sill support for balancing the cabinet.

7.Attach the cabinet to the window sill

by driving the screws (Type B) through the front angle into window sill.

8.Pull each Frame curtain fully to each window sash track, and repeat step 2.

Upper Guide
	Window sill
	Front Angle	Fig. 1
Window Sash	Upper guide
Foam-pe 11
Cabinet
Frame Curtain 1
Foam-pe	9	Fig. 2

INDOOR		OUTDOOR
	Sill Support 2
Bolt 3	Nut 4	Fig. 3
Frame Guide 9	Screw (Type A) 5		/2")
	Cabinet		1	Features and
			About 12.7mm (
INDOOR	OUTDOOR Fig. 4			Installation
Screw (Type B) 6			12.7mm (1/2")
	Sill support 2		About

Sash track

	Front Angle
	Screw (Type B) 6
Sill support 2	Fig. 5

13