Panasonic CW-XC64HU Ventilation, Air Direction, How to Secure the Drain Pipe, OptionalCW3H02502C

About the Controls on the Air Conditioner

Additional controls and important information.

Ventilation

The ventilation lever must be in the CLOSE position in order to maintain the best
cooling conditions. When fresh air is necessary in the room, set the ventilation
lever to the OPEN position.
The damper is opened and room air is drawn out.	CLOSE VENT OPEN
NOTE: Before using the ventilation feature, and prior to installing the front grille,		Part B
pull down part until level with part .		Part A

Air Direction

The direction of air can be controlled wherever you want to cool by adjusting the horizontal louver and the vertical louver.

•VERTICAL AIR-DIRECTION CONTROL • HORIZONTAL AIR-DIRECTION CONTROL

Controlled	Controlled	Controlled by Remote
manually	manually	Controller (Model: CW-XC84HU)

The vertical air direction is adjusted by	The horizontal air direction is adjusted by rotating
rotating the horizontal louver forward or	the vertical louver right or left manually or by
backward manually.	Remote Controller.

How to Secure the Drain Pipe

In humid weather, excess water may cause the BASE PAN to overflow. To drain the water, remove the DRAIN CAP and secure the DRAIN PIPE to the rear hole of the BASE PAN. Press the drain pipe into the hole by pushing down and away from the fins to avoid injury.(See Fig.1)

Optional(CW3H02502C)

1.Remove the rubber plug and slide the chassis out from the cabinet.(See Fig.2)

2.Install the drain pan over the corner of the cabinet where you removed the plug with 4 (or 2) screws.(See Fig.3)

3.Connect the drain hose to the outlet located at the bottom of the drain pan. You can purchase the drain hose or tubing locally to satisfy your particular needs. (Drain hose is not supplied).(See Fig.3)

4.Select the most appropriate connection from among the figures to the right (by considering the hole of the unit) to fit drain pan to your own unit.(See Fig.3)

5.Slide the chassis back into the cabinet. Reinstall the cabinet screws. Secure the cabinet to chassis by using screws. (See Fig.4)

Drain pipe
Drain cap		Fig. 1
Remove the
rubber plug		Fig. 2
CABINET
DRAIN	DRAIN HOSE
	Inside diameter 17mm (5/8")
PAN
	SCREW	Fig. 3
		Fig. 4

8