Using the VPAP IV and VPAP IV ST
Setting up your VPAP
1Connect the power cord to the socket at the rear of your VPAP.
2Plug the other end of the power cord into the power outlet.
3Connect one end of the air tubing firmly onto the air outlet.
4Connect the assembled mask system to the free end of air tubing. For information on assembling your mask, see your mask manual.
2
English |
1
3
4
WARNING
!• Make sure the power cord and plug are in good condition and the equipment is not damaged.
•Only ResMed air tubing and accessories should be used with the device. Do not use electrically conductive or antistatic hoses. A different type of air tubing or accessory may alter the pressure the patient receives, reducing the effectiveness of the treatment.
•Blocking the hose and/or air inlet of the device while in operation could lead to overheating of the device.
CAUTION
!• Be careful not to place the device where it can be bumped or where someone is likely to trip over the power cord.
•If you put the device on the floor, make sure the area is free from dust and clear of bedding, clothes or other objects that could block the air inlet.
Using the VPAP IV and VPAP IV ST | 3 |