Konica Minolta 300 instruction manual Connecting the probe

Page 15

4Pass the other end of the band outward through band fi xture B.

◆Take care not to twist the band.

5Fold back and secure the band with the hook- and-loop tape section.

◆When attaching the instrument to an arm, adjust the band length and fitting at this hook- and-loop tape section.

2)Connecting the probe

Connect the probeʼs connector plug into the Probe Connector on the instrument.

◆ M a k e s u r e t h a t p r o b e ʼ s connector plug is oriented correctly.

◆Do not connect it in with excessive force. Doing so may damage the connector.

◆Do not touch the connector terminals by hand. Contact failure may occur.

Band fi xture B Preparations

*Connecting the extension cable EC-300 between the PULSOX-300 and the probe extends the probe cable to a total length of 1m.

Extension Cable EC-300 (1m)

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents PULSOX-300 Safety Symbols Safety Precautions Foreword Contents Foreword Safety NotesAbout Probe Package ContentsSystem Diagrams and Accessories Names of Parts Foreword Difference from the SaO2 value to displayed value Foreword Disposal Method Preparations PreparationsConnecting the probe Installing the battery Starting the Measurement MeasurementPulse rate P.R Reading the displayEnding the Measurement About Auto Power-Off functionError Messages Trouble ShootingsCheck Points Check Points Check Points Check Points before repairing Display SpecificationProbes SR-5C, SP-5C, LM-5C, SD-5C Calculation Method for Displayed Values AppendixEMC Guidance Compliance Measurement Principle Oxygen Saturation vs. Oxygen Partial Pressure Manufacturer
Top Page Image Contents