Konica Minolta 300 instruction manual Installing the battery

Page 16

3) Installing the battery

Procedure

Preparations

1Turn the battery cover clockwise approximately 90 degrees to open the

cover.

◆ W h e n t u r n i n g t h e cover, keep the flat part of your finger on the coverʼs catch. This facilitates opening the cover with minimum force.

2Insert the battery into the battery compartment according to the polarity mark ( )shown on the rear of the instrument.

◆This instrument requires one AAA-size battery.

3Turn the battery cover c o u n t e r - c l o c k w i s e

a p p r o x i m a t e l y 9 0 degrees to close it.

◆Introduction of a new mechanism locks the cover automatically when it is closed.

14

Image 16

Contents PULSOX-300 Safety Symbols Safety Precautions Foreword Contents Safety Notes ForewordPackage Contents About ProbeSystem Diagrams and Accessories Names of Parts Foreword Difference from the SaO2 value to displayed value Foreword Disposal Method Preparations PreparationsConnecting the probe Installing the battery Measurement Starting the MeasurementReading the display Pulse rate P.RAbout Auto Power-Off function Ending the MeasurementTrouble Shootings Error MessagesCheck Points Check Points Check Points Check Points before repairing Speciﬁcation DisplayProbes SR-5C, SP-5C, LM-5C, SD-5C Appendix Calculation Method for Displayed ValuesEMC Guidance Compliance Measurement Principle Oxygen Saturation vs. Oxygen Partial Pressure Manufacturer