Waterproof Feature, To INSTALL/REMOVE Battery Pack

OPERATION

WATERPROOF FEATURE

Only the camera and camera cable are waterproof. All other components of the scope are water-resistant and should never be submerged.

Do not use this product for diving or any other prolonged underwater use. If the camera is exposed to rain or immersed in water, wipe it dry as soon as possible.

NOTE: Moisture or condensation does not indicate a mal- function of the waterproof feature.

Changes in temperature (such as moving the camera from a cold place into a warm place) may cause condensation in the form of water droplets on the lens or the inside of the camera. This is normal for all cameras. If this happens, turn the camera off and remove the battery cap and battery. Place it in a cool, dry area and leave the battery cap open. Wait at least an hour before you turn it on again.

TO INSTALL/REMOVE BATTERY PACK

See Figure 2, page 6.

To install the battery pack:

Unscrew the battery cap.

NOTE: Do not remove the gasket inside the cap.

Insert the battery pack in the direction shown. Make sure the raised rib on the battery pack aligns with the groove in the inspection scope.

Place the cap over the battery pack and push until the cap meets the threads at the end of the battery compartment.

Screw the cap on securely.

To remove the battery pack:

Power the inspection scope off. Unscrew the cap. The battery pack will disconnect and be easy to remove.

Do not attempt to use this product if the battery cap is not securely closed.

POWER BUTTON

See Figure 1, page 6.

When the inspection scope is turned on and the camera is pointed at an object, the LCD screen will show the image the lens is pointing at.

To turn on:

Press and hold the power button.

Release the power button when the screen turns on.

To turn off:

Press and hold the power button.

Release the power button when the screen turns off.

NOTE: The scope with shut off automatically if unused for five minutes.

ROTATE BUTTON

See Figure 1, page 6.

Pressing this button rotates the LCD image 180º. Push the button again to return the image to its original position.

LED BRIGHTNESS/DIMMER BUTTON

See Figure 1, page 6.

There are three levels of brightness for the LEDs. The lower right button turns the LEDs on and increases the brightness level.

The top right button decreases brightness and turns the LEDs off.

NOTE: Maintenance information begins on page 6 after

French and Spanish language sections. Figures (illustrations) start on page 7.

This product has a Two-year Limited Warranty.

For Warranty details go to www.ryobitools.com

5 — English