A&D UA-767NFC instruction manual Selecting the Clock Mode

Using the Monitor

Notes on the Built-in Clock

The monitor displays the clock as long as power is connected. Adjust the clock prior to use.

The current clock setting will be cleared if the batteries are removed, or power is not connected for approximately 30 seconds while the AC adapter is used. In this case, adjust the clock again.

When adjusting the clock, press the button to increase the value by

one, or press and hold the button to change the value continuously. The setting procedure cannot be reversed. If the wrong value is set, start the setting procedure again.

After 30 seconds of non-operation, the setting procedure will be automatically canceled.

To cancel the operation anytime, press the START button. During measurement, the clock adjustment is not available.

Selecting the Clock Mode

Two clock modes are available, 12-hour clock or 24-hour clock.

1. Press and hold the	button	Press and hold
until the year starts blinking.

2. Press and hold the button. “12H” appears on the display.

3.Press the button to switch between “12H” and “24H”.

4.Press the button to display the clock in the selected mode.

Press and hold

Press

12-hour

clock

24-hour

clock

8