Measurements
Before measurement, read “Notes for Proper Measurement” on the next page.
Normal Measurement
1. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.At heart level
2. Press the START button.
The number of data stored in memory is displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the figure at the right, as the measurement begins. The cuff starts to inflate. It is normal for the cuff to feel very tight. A pressure bar indicator is displayed, on the left edge of the display, during the inflation.
Note: If you wish to stop inflation at any time,
press the START button again.
3.When inflation is complete, deflation starts
automatically and 
(heart mark) blinks, indicating that the measurement is in progress. Once the pulse is detected, the mark blinks with each pulse beat.
Press START
Number of data in memory displayed
Zero display
Starts inflation
Pressurizing
Note: If an appropriate pressure is not obtained, the device starts to inflate again automatically. To avoid
4.When the measurement is complete, the systolic and diastolic pressure readings and pulse rate are displayed.
The cuff exhausts the remaining air and deflates completely.
5.Press the START button to turn the device off. After one minute of
Note: Allow at least three minutes between measurements on the same person.
Measurement in progress
Systolic pressure
Diastolic pressure
Pulse rate
Exhausts remaining
air automatically
12