●The Blood pressure monitor automatically carries out pressur- ization until the pressure that is best suited to the blood pres- sure measurement is reached.
●When the unit determines that an adequate pressure is not obtained, the unit starts pressurization again.
[Manual pressurization]
●Keep “POWER/MEASURE” switch held pressed until the pres- sure value you want to stop pressurization is reached (approxi- mately 40 mmHg higher than the maximal blood pressure). You can stop pressurization by the unit by releasing the switch at the aforementioned value is reached.
●Wait a while after the completion of pressurization. Then, the Q mark comes on and the unit automatically starts measur- ing your blood pressures.
●When the unit detects your pulse, the Q mark flashes on and off, then the unit gives your blood pressure value on the lower section of the display.
●Upon completion of measurement, the buzzer sounds and the unit automatically exhaust air from the cuff. Then, the maximal pressure/minimal pressure/number of pulses will appear on the display.
●As long as the unit functions correctly, the blood pressures and the number of pulses of the result are automatically stored in memory as one set of data.
●The number of pieces of data that can be stored in memory is 30 sets of measurements. When you measure your blood pres- sure though 30 sets of measurements have already been stored in memory, the earliest set of measurements is automatically deleted to accept new one.
- Eng 14 -