12Additional information
Problem | Remedy |
Sound is mono only. | • Check that the tuner is not set to FM mono (see Improving poor FM |
| reception on page 35). |
|
|
Considerable noise in | • Tune into the correct frequency. |
radio broadcasts. | • Connect the antenna (see Connecting the supplied antennas on page 18 |
| and Connecting external antennas on page 71). |
| • Fully extend the FM wire antenna, position for best reception, and |
| secure to a wall. |
| • Connect an outdoor FM antenna (see Connecting external antennas on |
| page 71). |
| • Adjust the direction and position for best reception. |
| • Connect an additional internal or external AM antenna (see AM loop |
| antenna on page 18 and Connecting external antennas on page 71). |
| • Turn off any other equipment that may be causing the noise or move it |
| away from the system unit. |
| • The tuning interval is incorrect for your country or region. Try switching |
| the tuning interval (frequency step) (see TV attenuator setting on page 67). |
|
|
Error Messages
Message | Description |
Child Lock | • This message appears when the front panel buttons are pressed when |
| the child lock feature is active. See Child lock setting on page 67 for more |
| on switching on/off the child lock. |
|
|
Rec Mode On | • Blinks rapidly for 2 seconds when an operation is prohibited because |
| the Recording Mode is on (see Recording mode on page 72). |
|
|
Phones In | • Blinks rapidly for 2 seconds when an operation is prohibited because |
| headphones are connected. |
|
|
96k Stereo | • Blinks rapidly for 2 seconds when an operation is prohibited because |
| the source is digital 88.2 or 96kHz PCM. |
|
|
No Surr. SP | • Blinks rapidly for 2 seconds when an operation is prohibited because |
| there is no surround speaker output. |
|
|
Muting | • Blinks rapidly for 2 seconds when an operation is prohibited because |
| the sound is muted (press the MUTE button to turn the sound on). |
|
|
Exit | • Appears briefly when a menu is automatically exited after a set period of |
| inactivity. |
|
|
SR+ Error | • Appears when there is a communication problem between the unit and |
| the plasma display. Check all connections and retry. |
|
|
76
En
