20 en ProgrammingNurseCall Relay Unit
4.2 | First use |
|
|
|
|
| |
4.2.1 | List of original factory settings |
|
| ||||
|
|
|
|
|
|
| |
| Parameter |
|
|
| Original Factory Setting | Page | |
|
|
|
|
|
| ||
| * Locating mode |
|
| On | 20 | ||
|
|
|
|
|
| ||
| * Identification number |
|
| No value | 20 | ||
|
|
|
|
|
| ||
| Assistance and fire priority |
|
| No | 21 | ||
|
|
|
|
|
| ||
| Special texts in German |
|
| No | 22 | ||
|
|
|
|
| |||
| Printer/display setup (Relay Plus Unit only) | None | 22 | ||||
|
|
|
|
|
| ||
| Speaker volume |
|
| Midrange | 25 | ||
|
|
|
|
| |||
| * Locating mode and identification number are set at first use. To change a value, reset the | ||||||
| unit. See Section 4.3.2 Resetting all the parameters and buffers, page 21. |
| |||||
4.2.2 | Parameters set by the NurseCall Main Unit |
| |||||
| The parameters listed below are programmed in the Main Unit and are applied to the Relay | ||||||
| Unit. See the NurseCall Main Unit user manual. |
|
| ||||
| – | Display mode |
|
|
|
| |
| – | Unit language |
|
|
|
| |
| – | Date and time |
|
|
|
| |
| – | Local acknowledgement and the access code |
|
| |||
| – | Output relay function and mode |
|
| |||
4.2.3 | Locating mode and identification number |
|
| ||||
| 1. | Disconnect the NurseCall Relay Unit from the |
| ||||
| 2. | Switch the NurseCall Relay Unit on with the switch located at the bottom of the unit. | |||||
|
| Wait for the following display to appear: |
|
| |||
|
|
|
|
|
|
| |
|
| LOCATING ? |
|
|
|
| |
|
| ( OFF / ON ) |
|
|
|
| |
|
|
|
| ||||
| 3. | Enable (ON) or disable (OFF) the indication of the transmitter position (locating mode) | |||||
|
| on the NurseCall Relay Unit display. It must be the same as in the NurseCall Main Unit. | |||||
| | Press | to disable or | to enable the locating mode. |
| ||
4.The identification number of the NurseCall Relay Unit must now be attributed.
RELAY UNIT ID: · ( + / - )
The identification number is attributed by the NurseCall Main Unit upon connecting the RS- 485 bus corresponds to the order of connection. It can also be set manually. The range for this value is (A, B, C, ..., Y, Z, a, b, c, d, e, f) for a maximum of 32 Relay Units.
Automatic attribution by the NurseCall Main Unit
5.a. Press 
or the Red button to erase any previous selection. The black box remains.
5.b. Connect the NurseCall Relay Unit to the 
or the Green button to
enable the automatic attribution. The next free identification number is attributed by the Main Unit and is displayed on the Relay Unit at the bottom right.
F.01U.252.722 V1 2011.12 | User Manual | Bosch Security Systems |