NurseCall Relay Unit | Programming en 21 |
|
|
Manual selection of the NurseCall Main Unit
5.a. Scroll with and to set manually the identification number. Confirm with or the Green button. The Relay Unit signalizes that it is not connected to the
NurseCall
RELAY UNIT OFF !!!
5.b. Connect the NurseCall Relay Unit to the
4.3 | Special settings |
After pressing three times quickly, you can enter special codes.
Enter Code
4.3.1 | Displaying the firmware version | |
| 1. | Type the code 194155. |
| 2. | The version of the firmware will be displayed for a few seconds. |
Software REV A
V2.02 BN111.242.00A
4.3.2 | Resetting all the parameters and buffers |
CAUTION!
Disconnect the
NOTICE!
The following procedure resets the NurseCall Relay Unit to its original factory settings. It erases all the parameters, as well as the alarms and events buffers. This reset is mandatory if you wish to change the locating mode or the identification number.
1.Type the code 194156.
2.When the unit resets, it plays a short melody and displays a temporary message.
Please Wait...
| 3. | After a few seconds, the unit goes back to the first use display. | |
| 4. | Select the locating mode and the identification number. See Section 4.2 First use. | |
4.3.3 | Assistance and fire priority | ||
| This command sets the assistance call and the fire alarm as priority calls. | ||
| This means that alarms of these types will be displayed first. | ||
| 1. | Type the code 123991. The unit plays a melody and a confirmation message is displayed. | |
|
|
|
|
|
| ASSISTANCE & FIRE |
|
|
| PRIORITY |
|
|
|
|
|
Bosch Security Systems | User Manual | F.01U.252.722 V1 2011.12 |