Dish Network 6.3 manual SETTING UP A TV1 UHF PRO REMOTE FOR THE, DISH PLAYER-DVR 522 AND 625 ONLY

SETTING UP A TV1 UHF PRO REMOTE FOR THE

DISH PLAYER-DVR 522 AND 625 ONLY

Use these special instructions only if you are going to use the green 1 UHF Pro key to control the TV1 side of your DISH Player-DVR 522 or 625.

When you are finished setting up the remote control, you’ll be able to operate the TV1 side of your DISH Player-DVR 522 or 625 from long distances.

1 Make sure the key is installed as described on pages C-1 and C-2.

2Make sure the UHF Antenna is attached to the back

of the receiver.

3Using the receiver’s front panel buttons, press MENU. Select the following onscreen items in this sequence:

a.System Setup.

b.Installation.

c.TV1 UHF Pro Setup.

4Select Enable from the TV1 UHF Pro Setup screen.

5Select System Info to open the System Information screen.

6Use the ARROW buttons to move the highlight to the address for the Remote Address as shown below. This is important - if you do not move the highlight, your remote will change the receiver's Remote Address and cause your Remote Control

11