1 to control the TV2 side of your receiver.
i1
UHF
Remote Addrs. | 5 |
TV Out | 3 |
Note: Highlight the 
Remote Address (the shaded area in the graphic above).
7Press the RECORD button on the green TV1 remote control you are setting up. If you get a warning that tells you to pick another address, continue on to the next step. If no warning appears, go to step 12 of this procedure.
8On the remote control, press and hold the SAT mode button for
about three seconds, until all the mode buttons light up, and then let go of the SAT button. The SAT mode button will blink.
9Use the number buttons to enter any number from 1 to 16, except for the address shown for 
on your screen.
Write down the number you entered:
10Press the POUND (#) button. If you entered the address correctly, the SAT mode button will flash three times.
11Make sure the System Information screen shows 
UHF and that this address matches the number you entered in step 9.
12Select Done to close the System Information screen. If nothing happens, press RECORD, and then select Done.
12
