Dish Network 6.3 manual What’s Wrong, What You Can Do, Happening, Remote Control Modes on page

What’s	What’s Wrong	What You Can Do
Happening
Your remote	• The remote control	• Make sure the remote control is in the
control isn’t	is in the wrong	correct mode. For example, if you want
working	mode.	to use the satellite receiver, put the
		remote control in SAT mode (see
		Remote Control Modes on page 1).
	• You might be	• Make sure you are using the correct
	using the wrong	remote control (TV1 or TV2) for your
	remote control	locations (multi-room receivers only).
	(TV1 or TV2).
	• Your batteries are	• Change the batteries as described on
	worn out.	page C-2.
	• The remote	• Check the A/B switch setting as
	control’s A/B	described on page 10.
	switch is in the	For all receivers except for the
	wrong position	DISH Player-DVR 942, ViP222
		and ViP622 DVR: leave the A/
		B switch in the A position.
When you press	• The remote control	• See Programming the Remote to
the remote	may not be set up.	Control Your TV on page C-4 and
control Mute or		Programming for Other Equipment on
Volume button,		page 2.
nothing
happens.	• Maybe you’re	• Set up the remote to control either
	trying to control	TV volume or tuner/amplifier volume,
	TV volume but	whichever you want. See page 6.
	you set up the
	remote to control a
	tuner or amplifier
	in AUX mode.
Your UHF Pro	• You may be	• Make sure the UHF antenna is
remote control	experiencing	connected to the receiver and not
does not work	interference from	touching anything else.
well from far	objects near your	• Vary the tilt angle of the receiver's UHF
away.	receiver antenna.
		antenna. Locate the UHF antenna tip
		away from other electronics equipment
		or metal surfaces, even if separated by
		wooden shelving.
		• Move the receiver to different
		locations. For best results, place the
		receiver as high as possible, above all
		other equipment in your entertainment
		center.
		• Place the UHF antenna outside the
		entertainment center by using a coaxial
		cable to connect it to the receiver.
		• Move any nearby off-air antenna away
		from the UHF remote antenna. Do not
		place an off-air antenna on your
		receiver.
Your PIP	• Your receiver	• Upgrade to a receiver with this feature.
(Picture-In-	doesn’t use PIP.	• Press the Mode button on the front
Picture) button	• Your receiver isn’t
		panel (if available).
isn’t working.
	in Single Mode.

22