4Press POUND (#). If you entered the address correctly, SAT will flash three times. Write down the number you entered in the reference tables on page 26.
5Press RECORD. Make sure the Remote Address you see on the System Information screen is the same as the one you entered in step 3. If it isn't, the remote cannot control the receiver. Press RECORD a second time.
6Press SELECT to close the System Information screen.
CHANGING THE UHF FREQUENCY USING THE A/B
SWITCH (DISH PLAYER-DVR 942, VIP222, AND VIP622 DVR ONLY)
All receiver models except the DISH
Your remote has a switch to change the UHF frequency that your remote control uses. It comes preset to the A position but you can change the setting to the B position to lessen the likelihood of any other UHF remote interfering with yours.
1Remove the battery cover from the remote control.
2Use a small screw driver or a paper clip to carefully change the setting.
3Put the battery cover back on the remote control.
4Use the SYS INFO button on the front panel to open the System Information screen.
5Press RECORD on the remote control.
6Make sure the remote address on the System Information screen shows the correct band information:
•Switch Position A - IR/UHF Pro Band A
•Switch Position B - IR/UHF Pro Band B
A
B
Battery
10
