Battery Installation

IMPORTANT! Use only a Power Wheels® 12 volt 12Ah battery. Use of any other battery will damage your scooter. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels® 12 volt charger before operating your scooter for the first time. Charge the battery for at least 14 hours after each use of the scooter. Never charge the battery longer than 30 hours. Failure to follow these instructions may damage your battery and will void your warranty.

For best performance, use only a Power Wheels® 12 volt 12 Ah battery (part number: 00801-1048). Please contact your local Power Wheels® Authorized Service Center for a replacement battery. To find the authorized service center nearest you, see page 24.

Footboard

Press

Release

Button

•While pressing the release button on the scooter floor, lift the footboard from the scooter.

12 Volt

Battery

Motor Harness

Connector

•Plug the motor harness connector into the battery socket.

Push firmly to make sure the motor harness connector is completely inserted into the battery.

•Fit the battery into the battery compartment, as shown.

•At an angle, insert the front tab on the footboard into the slot in the scooter floor.

•Push down on the footboard to “snap” it into place.