Quantum 610 owner manual Display Pad, Profile and Speed Indicator, Actuator Indicator

Page 47

V I I . O P E R A T I O N

Display Pad

The display pad is located directly in front of the joystick. It contains the horn key, battery condition meter, profile and speed indicator, and the actuator indicator. See figure 36.

Horn Key

The horn key activates the horn.

Battery Condition Meter

The battery condition meter is a 10-segment illuminated display that indicates that the Microdrive is powered on and also gives the status of the batteries, the controller, and the power chair electrical system.

!Red, yellow, and green lights lit: Batteries charged; controller and electrical system OK.

!Red and yellow lights lit: Charge batteries if possible; controller and electrical system OK.

!Red lights only lit or slow flash: Charge batteries as soon as possible; controller and electrical system OK.

!Rapid flash of lights: Indicates a fault in the controller or the electrical system. See “Error Codes.”

!Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you get “ripple up and down of lights,” turn off the controller, allow the joystick to return to the neutral position, then turn on the controller.

NOTE: If you still get “ripple up and down of lights,” contact your Quantum Rehab Specialist.

NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, reminding you the batteries need to be charged immediately!

Profile and Speed Indicator

The profile and speed indicator is a 5-segment illumi- nated display that indicates speed setting as well as drive profile.

Actuator Indicator

The actuator indicator is a 4-segment illuminated dis- play that indicates power recline, power tilt, power leg rest, and power elevating seat actuator modes.

Joystick Interface Module

The joystick interface module provides a means to enable or disable the horn button, mode switch, on/off switch, and speed adjustment dial.

NOTE: When a toggle switch is set to “J/S,” the joystick has control of a particular function. When the toggle switch is set to “Local,” control of this function is disabled at the joystick.

Figure 36. Microdrive Display Pad

Quantum 610

www.quantumrehab.com

47

Image 47

Contents Page F E T Y G U I D E L I N E S III N T E N T SInformation Exchange SafetyN T R O D U C T I O N PURCHASER’S AgreementMy Quantum Rehab Specialist Pride Owners ClubS a F E T Y Product Safety SymbolsS a F E T Y Modifications Pre-Ride Safety CheckIncline Information Weight LimitationsTire Inflation Public Streets and Roadways Preventing Unintended Movement Braking InformationCornering Information Stairs and Escalators Freewheel ModeOutdoor Driving Surfaces Stationary Obstacles Steps, Curbs, etcLift/Elevation Products TransfersDoors ElevatorsReaching and Bending Inclement Weather PrecautionsMotor Vehicle Transport Positioning BeltsAlcohol BatteriesRemovable Parts Prescription Drugs/Physical Limitations Electromagnetic and Radio Frequency Interference EMI/RFI Quantum I . Y O U R P O W E R C H a I RQuantum 610 Specifications Electrical Components Quantum 610 Power BaseCharger Inhibit Connector To engage or disengage the drive motors Manual Freewheel LeversA S S E M B L Y Initial AssemblyTo install the seat Seat InstallationTo install the power seat Power Seat Option InstallationCan also change the seat base angle dump Comfort AdjustmentsSeat Height and Seat Angle Adjustment O M F O R T a D J U S T M E N T SSeat Position Seatback Angle AdjustmentManual Recline Seatback Adjustment Controller Position Armrest Width AdjustmentArmrest Angle Adjustment Foot Platform Angle Adjustment Foot Platform Height AdjustmentFoot Platform Depth Adjustment Heavy Duty Drop-in Leg Rests Swing-away FootrestsElevating Leg Rests Multi-Axis Foot Plates To change the seat height through toggle switch Power Elevating Seat OptionalCharging the Batteries B a T T E R I E S a N D C H a R G I N GBatteries and Charging Battery Break-in To charge the batteries using the off-board chargerTo charge the batteries using the optional onboard charger Frequently Asked Questions FAQs What about public transportation? Why do my new batteries seem weak?How can I ensure maximum battery life? How should I store my power chair and its batteries?Keypad I . O P E R a T I O NFlight Controller JoystickTo lock the Flight controller Battery Condition MeterLock Mode On/Off KeySpeed Keys Sleep Mode If EnabledError Codes Error Code Probable Cause Possible SolutionVSI consists VSI Electronic ControllerSpeed/Profile Keys Red, yellow, and green lights lit Batteries chargedActuator Keys and Actuator Lights For Optional Equipment Motor ConnectorsBattery Connector Actuator Connector OptionalThermal Rollback Charger Inhibit Connector OptionalVSI Error Codes Remote Plus consists of the following Remote Plus ControllerRemote Plus To select a speed setting Mode Key Speed Settings Sleep Mode Right/Left Turn Indicator Keys Optional Power Accessory Indicator Optional Power Accessories OptionalRemote Plus Error Codes Microdrive Controller consists Microdrive ControllerJoystick Interface Module Profile and Speed IndicatorActuator Indicator Display PadTo change the speed To select a profile settingSpeed Adjustment Drive Profile SelectionFlashing Lights Diagnosis Solution I I . C a R E a N D M a I N T E N a N C E Care and MaintenanceShould your power chair come in contact with water TemperatureMonthly Checks Daily ChecksWeekly Checks To check the brakesStorage Cleaning Instructions Wheel ReplacementTo replace the batteries Battery ReplacementBattery Installation Corrective Maintenance When to See Your Quantum Rehab Specialist for ServiceW a R R a N T Y Exclusions also include components with damage caused by Reconditioned Units WarrantyWarranty Exclusions Service Checks and Warranty ServiceT E S Quality Control Quantum

Related manuals

Manual 24 pages 41.97 Kb