V I . B A T T E R I E S A N D C H A R G I N G
BATTERIES AND CHARGING
The Jazzy 600 XL uses two
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds. Wash hands after handling.
Charging the Batteries
The battery charger is essential in providing long life for your power chair batteries. It is designed to optimize your power chair’s performance by charging the batteries safely, quickly, and easily. The battery charging system consists of the onboard battery charger, the charger circuit fuse, and the ammeter. The ammeter indicates the rate of charge necessary to fully recharge the batteries. It is also a good indication of whether or not the charger is working. The ammeter and the charger are only functional when the charger power cord is plugged into a wall outlet. The charger circuit has an ATO fuse that protects the ammeter. See figure 7.
WARNING! You must recharge your power chair’s batteries with the supplied onboard battery charger. Do not use an
PROHIBITED! Removal of grounding prong can create electrical hazard. If necessary, properly install an approved
PROHIBITED! Never use an extension cord to plug in your battery charger. Plug the charger directly into a properly wired standard wall outlet.
To charge the batteries using the onboard charger:
1.Position the rear of your power chair close to a standard wall outlet.
2.Be certain the controller power is turned off and the freewheel levers are in the engaged position. See III. “Your Power Chair.”
3.Plug the charger power cord into the charger power cord receptacle on the power base, then into the wall outlet.
NOTE: The power chair incorporates an inhibit function that disables the power chair when the charger is plugged into a wall outlet.
4. We recommend you charge the batteries for 8 to 14 hours.As the batteries charge, the ammeter needle slowly drops to 0.
NOTE: The ammeter indicates how much charge is needed to fully charge the batteries. Wait about a minute for the charger to warm up. The ammeter may move as high as 5.5 amps, then gradually move back down to 0 amps as the batteries charge.
5.When your power chair’s batteries are fully charged, the needle vibrates on or about the 0 mark on the ammeter. Disconnect the charger power cord, wind up the cord, and store it in a safe place.
To charge the batteries using the optional
1.Position the front of your power chair next to a standard wall outlet.
2.Becertainthecontrollerpoweris turnedoff.
3.Plug the
4.
28 | www.pridemobility.com | Jazzy 600 XL |