Pride Mobility 400 manual O P E R a T I O N, Power Switch Operation, Hand Control Operation

Page 12

I V . O P E R A T I O N

POWER SWITCH OPERATION

The lift system is equipped with an ON/OFF switch that enables/disables operation. Toggle the ON/OFF switch to the “I” position to turn the power on; to the “O” position to turn the power off. See figure 6.

NOTE: The ON/OFF switch also functions as the circuit breaker reset button. See figure 6.

HAND CONTROL OPERATION

The hand control for the lift system operates the arm in six directions: up/down, rotate left/right and in/out. Press and hold the appropriate button until the desired position is obtained. See figure 7.

NOTE: Store the hand control in the hand control bracket (located on the boom) after operation and during storage.

LIFTING THE MOBILITY PRODUCT

WARNING! Before operating the lift system for the first time, be absolutely certain you have the proper docking device for your mobility product installed.

WARNING! Always operate the lift and mobility device being lifted on a flat, level surface

ON/OFF SWITCH

ON

OFF

Figure 6. ON/OFF Switch

ROTATE LEFT

ROTATE RIGHT

UP

BOOM OUT*

DOWN

BOOM IN*

 

* NO FUNCTION

 

ON 2-AXIS LIFT

Figure 7. Hand Control

1.Prepare your mobility product for transport. Ensure that the power is off and properly secure the batteries. You may also need to lower the tiller and/or remove the seat.

2.Position your mobility product on the ground behind the installed lift. Be sure that there is ample space between the mobility product and the vehicle bumper to ensure that the mobility product will not hit the bumper while being raised. If the mobility product is too far from the vehicle’s bumper, the mobility product will be dragged when attempting to lift it.

3.Position the boom-arm over the mobility product.

4.Operate the lift in the downward direction. The lift strap should drop straight down to the T-bar or docking device collar.

WARNING! Inspect the lifting strap before each use for twisting, fraying, signs of wear, loose parts, damage or debris. If you discover a problem, contact your authorized Pride Provider for maintenance and repair.

WARNING! Avoid unloading into vehicular traffic.

NOTE: Keep tension on the lifting strap with your free hand when lowering the boom-arm.

WARNING! Do not extend the lifting strap past the warning label located on it.

12

www.pridemobility.com

Commander 400

Image 12
Contents Commander F E T Y G U I D E L I N E S N T E N T S IIIN T R O D U C T I O N Internet and Private Purchases PURCHASER’S AgreementShipping and Delivery Information ExchangeProduct Safety Symbols S a F E T YS a F E T Y Installation Lifting CapabilitiesLifting NON-PRIDE Products PRE-LIFT InspectionI . Installation Lift System InstallationFollow these steps for installation BOOM-ARM Adjustment To raise or lower the upper postSee figure Lift SystemElectrical Wiring Installation To raise or lower the boom armI . Installation Power Switch Operation O P E R a T I O NHand Control Operation Lifting the Mobility ProductTo prevent dragging Troubleshooting To reset the main circuit breakerTo restore proper lifting strap travel Lift will not OperateManual Override Operation Manual Overide OperationStorage and Operation Temperatures C a R E a N D M a I N T E N a N C EPerform prior to daily use Perform every 6 monthsTHREE-YEAR Transferable Limited Warranty Service Checks and Warranty ServiceI . W a R R a N T Y Exclusions also include components with damage caused byT E S Page INFMANU4414