Pride Mobility 400 manual I . Installation, Lift System Installation

Page 8

I I I . I N S T A L L A T I O N

LIFT SYSTEM INSTALLATION

NOTE: The lift system is an exterior-rated lift system. Refer to the online compatibility database located at www.pridemobility.com for information concerning lift system/vehicle compatibility, or contact your authorized Pride Provider.

WARNING! The lift system should be installed by an authorized service technician only.

WARNING! At least two people should lift the lift system into the rear of the vehicle. Use proper lifting techniques and avoid lifting beyond your physical capability.

WARNING! Avoid pinch points! Do not hold the lift frame by the pivot points when installing the lift system.

NOTE: Footprint the mounting area along with the lift and mobility device to make sure all clearances pass above and below vehicle without any interference before starting installation.

NOTE: Use only the supplied hardware to install the lift system.

NOTE: To preserve vehicle-system data, the vehicle’s power system may need to be connected to an alternate power source prior to battery removal. Refer to the vehicle’s owner’s manual for information on proper battery-disconnection instructions.

Follow these steps for installation:

1. Install the lift system securement system to the vehicle.

NOTE: Securement systems vary depending on vehicle manufacturer. Pride recommends use of only the securement system provided with the lift and that you follow all instructions provided by the manu- facturer for installation.

2.Connect the lift system to a power source. See “Wiring Harness Installation.”

3.Ensure that all mounting hardware is fully tightened and all required clearances have been achieved.

NOTE: The lift system may include an optional set of L-Base extensions. For information on L-base extension installation, refer to the supplemental instructions or contact your authorized Pride Provider.

NOTE: The lift system is equipped with a power base, which is an automated device designed to rotate the boom arm left and right.

8

www.pridemobility.com

Commander 400

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Commander F E T Y G U I D E L I N E S N T E N T S IIIN T R O D U C T I O N Internet and Private Purchases PURCHASER’S AgreementShipping and Delivery Information ExchangeProduct Safety Symbols S a F E T YS a F E T Y Installation Lifting CapabilitiesLifting NON-PRIDE Products PRE-LIFT InspectionFollow these steps for installation I . InstallationLift System Installation BOOM-ARM Adjustment To raise or lower the upper postSee figure Lift SystemElectrical Wiring Installation To raise or lower the boom armI . Installation Power Switch Operation O P E R a T I O NHand Control Operation Lifting the Mobility ProductTo prevent dragging Troubleshooting To reset the main circuit breakerTo restore proper lifting strap travel Lift will not OperateManual Override Operation Manual Overide OperationStorage and Operation Temperatures C a R E a N D M a I N T E N a N C EPerform prior to daily use Perform every 6 monthsTHREE-YEAR Transferable Limited Warranty Service Checks and Warranty ServiceI . W a R R a N T Y Exclusions also include components with damage caused byT E S Page INFMANU4414
Top Page Image Contents