Pride Mobility 400 manual To prevent dragging

Page 13

I V . O P E R A T I O N

5. Ensure that the docking device is properly attached.

6. Operate the lift in the upward direction.

WARNING! Pinch/Crush Hazard! Always keep hands clear of the lifting strap while the lift system is lifting/lowering a mobility product. Ensure that all people and objects are a safe distance away from the mobility product being lifted/lowered and clear from path of travel.

NOTE: Do not drag the mobility product into position using the lift. If dragging occurs, your mobility product is too far away from the vehicle.

To prevent dragging:

Figure 8. Lifting the Mobility Product

„Release the lifting strap tension.

„Correct the position of the mobility product.

„Attempt the lift again.

400lbs

181kgs

MANDATORY! The lift system is designed to lift a maximum weight of 400 lbs. (181 kg). Do not exceed this limit.

7.If the mobility product begins to tilt, lower it completely and adjust the docking device by moving the pick-up bar in the direction of the tilt (when using a C-arm).

8.Tighten the pick-up bar once the proper balance point has been found (when using a C-arm).

9.Once the mobility product is raised high enough to fit into the vehicle, stop the lift. See figure 8.

10.Rotate the boom-arm toward the vehicle. When the mobility product is securely in the vehicle, lower the mobility product into the vehicle and secure it.

NOTE: Rotate the boom arm to the desired position to facilitate installation.

NOTE: Ensure the mobility device is secured against slipping once installed in the motor vehicle.

11. Shut off the lift system to prevent any accidental movement when transporting your mobility product.

WARNING! Your lift system was designed to be mounted primarily in a motor vehicle. Mounting your lift system on a platform, where the height of the lift may cause the lifting strap to extend beyond a safe point, can damage the lift system and injure the lift operator.

WARNING! Do not overtighten the strap. Doing so may put excessive strain on the motor, causing the circuit breaker to trip.

Commander 400

www.pridemobility.com

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Commander F E T Y G U I D E L I N E S III N T E N T SInternet and Private Purchases PURCHASER’S Agreement N T R O D U C T I O NShipping and Delivery Information ExchangeS a F E T Y Product Safety SymbolsS a F E T Y Lifting Capabilities InstallationLifting NON-PRIDE Products PRE-LIFT InspectionLift System Installation I . InstallationFollow these steps for installation To raise or lower the upper post BOOM-ARM AdjustmentSee figure Lift SystemTo raise or lower the boom arm Electrical Wiring InstallationI . Installation O P E R a T I O N Power Switch OperationHand Control Operation Lifting the Mobility ProductTo prevent dragging To reset the main circuit breaker TroubleshootingTo restore proper lifting strap travel Lift will not OperateManual Overide Operation Manual Override OperationC a R E a N D M a I N T E N a N C E Storage and Operation TemperaturesPerform prior to daily use Perform every 6 monthsService Checks and Warranty Service THREE-YEAR Transferable Limited WarrantyI . W a R R a N T Y Exclusions also include components with damage caused byT E S Page INFMANU4414
Top Page Image Contents