Sunrise Medical M11, F11 Backrest Angle Adjustment Figure, Seat Height Adjustment Figures 9

8 E n g l i s h

V . S e t - u p ,

A d j u s t m e n t & U s e

H. BACKREST ANGLE ADJUSTMENT (Figure 8)

A backrest angle adjustment is standard.

Adjustment on Seat Frame

1.Remove the front securing bolt (A) on the side of the backrest hinge plate.

2.Loosen the lower rear bolt (B).

3.Set at desired angle. There are four holes (in 4º increments) to choose from.

4.Reinstall the front bolt and tighten both bolts securely.

I. SEAT HEIGHT ADJUSTMENT (Figures 9 & 10)

The seat height can be adjusted from 17.5" - 21.5" (M11) and 19" - 23" (F11) at 1" increments.

1.Remove the seat.

2.Reposition all four of the seat mounts (C) to desired position by removing pins (D), adjusting mounts and replacing pins.

3.Ensure that the top of all seat mounts sit at the same height (except as noted below).

4.Replace seat.

NOTE– 1" of seat angle can be set by lowering the rear post two hole positions.

In all configurations of seat height and fixed tilt angles, ensure that both the front and rear latches (2) are all properly engaged.

8

B

A

9

C

D

Front Mounts

J. TM40 SINGLE OR DUAL SWITCH ACTUATOR CONTROLLER (Figure 11)

The TM40 actuator controller can be used to activate the tilt mechanism with either single or dual switch controls.

1.Plug limit switch harness assembly (1) into TM40 limit switch jack (2).

2.Plug single switch (3) into TM40 single switch jack (4) OR plug dual switch (5) into TM40 dual switch jack (6).

3.Plug TM40 into the QTRONIX Power Module (7).

4.Use mating plugs (8) to connect the TM40 to the tilt actuator.

10

C

D

Rear Mounts

DRIVE INHIBIT		TILT STOP	1	11
SWITCH		SWITCH		DUAL
				SWITCH
TILT ACTUATOR				5
UPRIGHT STOP			2
SWITCH			6
			4
				3
				SINGLE
				SWITCH
8
				TO ONBOARD
			7	CHARGER
VSI CONTROLLER	OR
9-PIN
CONNECT
		QTRONIX POWER MODULE
930584 Rev. A