Invacare Tracer DLX, SX Recliner, Tracer Titan Elevating Legrest Assembly Installation Figure

Page 17

FRONT RIGGINGS

PROCEDURE 1

 

 

Phillips Screw

Bolt and Locknut

Spacer

Heel Loop

Slide Tube

Locknut

Footplate

FIGURE 3 - HEEL LOOP REPLACEMENT

ELEVATING LEGREST ASSEMBLY INSTALLATION (FIGURE 4)

1.Place legrest assembly on the outside of the wheel- chair and install the hinge plates onto the hinge pins on wheelchair frame (FIGURE 4).

2.Rotate legrest assembly toward the inside of the wheelchair until it locks in place (FIGURE 4).

NOTE: The footplate will be on the inside of the wheel- chair when locked in place.

3.Repeat this procedure for other legrest assembly.

4.After seated in wheelchair, adjust footrest to cor- rect height by loosening the locknut and sliding the lower footrest assembly tube up or down until desired height is achieved.

5.Tighten locknut securely.

 

Legrest Release Handle

Hinge Pins

Calfpad

Assembly

 

Hinge Footplate

Plates

Bolt and

Locknut

Lower

Footrest

Assembly

FIGURE 4 - ELEVATING LEGREST INSTALLATION

6.To release the legrest, push the legrest release handle toward the inside of the wheelchair (facing the front of the wheelchair) and swing the legrest assembly to the outside of the wheel- chair.

ADJUSTING THE ELEVATING LEGREST ASSEMBLY (FIGURE 5)

1.To adjust the elevating legrest, raise legs until the desired height is obtained.

2.To reposition legrest to normal position, support leg with one (1) hand and push release lever down- ward with other hand.

3.To adjust the calfpad, turn pad towards the out- side of the wheelchair.

4.Slide the calfpad up or down until the desired po- sition is obtained.

5.To secure the calfpad, turn the calfpad towards the inside of the wheelchair.

Release Lever

Calfpad Rotated for

 

Height Adjustment

Calfpad

FIGURE 5 - ADJUSTING THE ELEVATING

LEGREST ASSEMBLY

F

R O N T

R

I

G G I N G S

17

Image 17
Contents Tracer R SX Tracer R SX Recliner Tracer R Titan Tracer R DLX I N G Table of Contents Wheelchair TIE-DOWN Restraints and Seat Positioning Straps Special NotesOperating Information Safety SummaryTo Healthcare PROFESSIONALS/ASSISTANTS Percentage of Weight Distribution SAFETY/HANDLING of WheelchairsStability and Balance Coping with Everyday ObstaclesREACHING, Leaning Backwards REACHING, Leaning Bending ForwardFunctional Reach from a Wheelchair Tipping Curbs Method 1 Wheelchair TippingWithout Step Tubes Tipping Curbs Method 1 Wheelchair with Step TubesTransferring to and from Other Seats StairwaysOpening Folding and Unfolding the WheelchairRecliner Models ClosingI F I C a T I O N S SpecificationsT I O N S Initially Inspect Adjust Weekly Monthly Periodically Safety Inspection ChecklistMaintenance TroubleshootingMaintenance Safety Precautions Suggested Maintenance ProceduresSwingaway Footrest Height Adjustment Figure Heel Loop Replacement FigureSwingaway Footrest Assembly Installation Figure Adjusting the Elevating Legrest Assembly Figure Elevating Legrest Assembly Installation FigureWhelchairs Equipped With Height Adjustment Knobs Figure Adjusting Armrest Height Adjustable Height Arms onlyWheelchairs Equipped With Height Adjustment Levers Figure Using Using or Replacing FLIP-BACK Armrest FigureRemoving or Replacing Armrest Figure ReplacingReplacing SCREW-ON Back Upholstery Figure Assembling the Back Cane to the Wheelchair FigureReplacing the SLIP-ON Back Upholstery Figure Replacing Seat Upholstery Figure Adjusting Seat Depth FigureAdjusting Seat Width Figure Tracer DLX Built Before March 13 Permanent Axles Figure REMOVING/INSTALLING the Rear WheelsQuick-Release Axles Figure Replacing Rear Wheel Handrim Figure REPLACING/REPAIRING Rear Wheel TIRE/TUBEAdjusting the QUICK-RELEASE Axle Figure Front Caster Mounting Adjustments Figure REPLACING/REPAIRING Front Caster TIRE/TUBEAdjusting The Anti-tippers Figure INSTALLING/ADJUSTING the ANTI-TIPPERSInstalling The Anti-tippers Figures 1 Wheel Lock Adjustment Wheel Lock Adjustment FigureChanging SEAT-TO-FLOOR Height Procedure SEAT-TO-FLOOR HeightChanging SEAT-TO-FLOOR Height Recliner Frame Style C L I N E R Recliner Operation FigureReplacing the Headrest Pillow Figure Replacing the HEADREST/BACK UpholsteryHeadrest Upholstery Figure Back Upholstery FigureRemoving REMOVING/INSTALLING the Spreader BAR FigureInstalling REMOVING/INSTALLING Rear Wheels REMOVING/INSTALLING the Rear Wheels FigureInstalling the Amputee Bracket Installing the Amputee Bracket FigureSafety and Maintenance Installing the Seat Positioning Strap FigureInstalling the Crutch and Cane Carrier Figure Mounting Installing the Telescoping I.V. RODRepositioning the Upper Mount Repositioning The Upper Attachment FigurePage Tracer DLX Limited WarrantyOne Invacare Way