Invacare SX Recliner, Tracer Titan, Tracer DLX manual Installing the Amputee Bracket Figure

PROCEDURE 9 OPTIONS

O P T I O N S

This Procedure Includes the Following:

Installing the Amputee Bracket

Installing the Seat Positioning Strap

Installing the Crutch and Cane Carrier

Installing the Telescoping I.V. Rod

NOTE: The procedures in this section of the manual apply to NON-RECLINER wheelchairs, EXCEPT In- stalling the Seat Positioning Strap.

WARNING

After ANY adjustments, repair or service and BE- FORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

INSTALLING THE AMPUTEE BRACKET (FIGURE 1)

1.Refer to the following chart or FIGURE 1 to deter- mine the mounting position of the amputee bracket:

2.Install the amputee bracket on the wheelchair frame to the position determined in STEP 1.

NOTE: Make sure the axle spacer is pointing towards the outside of the wheelchair.

3.Install the two (2) hex screws and locknuts that secure the amputee bracket to the wheelchair.

4.Install the rear wheels onto the wheelchair. Refer to REMOVING/INSTALLING THE REAR WHEELS in PROCEDURE 9 of this manual.

SEAT-	*BRACKET	AXLE SPACER	SIDE OF	AXLE MOUNTING
TO-FLOOR		POSITION	WHEELCHAIR	POSITION
		(on bracket)		(on wheelchair)
ADULT	A	DOWN	RIGHT	TOP
ADULT	B	DOWN	LEFT	TOP
HEMI	B	UP	RIGHT	BOTTOM
HEMI	A	UP	LEFT	BOTTOM

*"A" and "B" are stamped on the sides of the amputee bracket.

BRACKET "A" BRACKET "B"

Locknuts

LEFT RIGHT

ADULT RIGHT

Axle Spacer Towards OUTSIDE

of Wheelchair

REAR VIEW OF

AMPUTEE BRACKET

ADULT LEFT

Axle Spacer Towards OUTSIDE

of Wheelchair

Hex Screws

HEMI LEFT HEMI RIGHT

FIGURE 1 - INSTALLING THE AMPUTEE BRACKET

34