RECLINER | PROCEDURE 8 |
|
|
UPRIGHT POSITION
Handle
Release
Levers
Wheelchair
Level
Surface
RECLINED POSITION
Wheelchair
Release
Levers
Level
Surface
FIGURE 1 - RECLINE OPERATION
REPLACING THE HEADREST PILLOW (FIGURE 2)
1.Unfasten straps of headrest pillow from behind headrest upholstery and remove the existing headrest pillow from headrest.
2.Center new/existing headrest pillow onto the front of the headrest upholstery.
3.Pull straps of new/existing headrest pillow around the back canes.
4.Pressing firmly, attach the fastening strips of the new/ existing headrest pillow to the fastening strips on the back of the headrest upholstery.
Headrest
Upholstery
Fastening | Strap |
Strips |
|
Strap Headrest
Pillow
FIGURE 2 - REPLACING THE HEADREST PILLOW
REPLACING THE HEADREST/BACK UPHOLSTERY
Headrest Upholstery (FIGURE 3)
1.Remove the headrest pillow. Refer to REPLAC- ING THE HEADREST PILLOW in this procedure of the manual.
2.Remove the six (6) mounting screws that se- cure the headrest upholstery to the headrest extension tubes.
3.Secure NEW headrest upholstery onto headrest extension tubes with the existing six (6) mounting screws.
4.Install headrest pillow. Refer to REPLACING THE HEADREST PILLOW in this procedure of the manual.
Back Upholstery (FIGURE 3)
1.Disengage one (1) side of the spreader bar. Refer to
REMOVING/INSTALLING THE SPREADER BAR in this procedure of the manual.
R E C L I N E R
31