Invacare Lightweight manual Adjusting Footplate Height, Spring Button Height, Bolt-In-Place Height

Page 32

SECTION 4—FRONT RIGGINGS

Adjusting Footplate Height

Spring Button Height

NOTE: For this procedure, refer to FIGURE 4.2.

NOTE: This procedure applies to the swingaway front riggings and swingaway elevating legrest.

1.Remove the front rigging assembly. Refer to Installing/Removing Front Riggings on page 31.

NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.

2.Pull the cam lock lever up to unlocked position.

NOTE: The elevating legrest has two sets of release buttons, one set above the other. Each set will be visible one at a time allowing finer footplate height adjustment.

3.Push in the release buttons and reposition the footplate assembly to the desired height.

4.Ensure that the release buttons fully protrude from holes on both sides of the front rigging support.

Front Rigging Support

Release Button

Adjustment Footplate

Holes Assembly

Cam Lock Lever

5.Rotate cam lock lever down to locked position.

6.Repeat this procedure for the other footplate, if necessary.

NOTE: Swingaway footrest shown.

FIGURE 4.2 Spring Button Height

7.Reinstall the swingaway front rigging assembly. Refer to Installing/Removing Front Riggings on page 31.

Bolt-In-Place Height

NOTE: For this procedure, refer to FIGURE 4.3 on page 33.

NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.

1.Remove the swingaway front rigging. Refer to Installing/Removing Front Riggings on page 31.

NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.

2.Pull the cam lock lever up to the unlocked position.

3.Using a screw driver to hold the threaded rivet in position, remove the button head screw from the threaded rivet.

4.Remove the threaded rivet and button head screw securing the footplate assembly to the front rigging support.

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Lightweight, Standard and Heavy Duty Wheelchairs Lightweight, Standard and Heavy Duty Wheelchairs Table of Contents Front Riggings Table of Contents Register Your Product Complete and mail the form on the nextProduct Registration Form City State/ProvinceFold here Cut Along Line Special Notes Wheelchair TIE-DOWN Restraints and Seat RestraintsSpecial Notes Label Location Important NoticeLightweight Typical Product ParametersTypical Product Parameters Anti-Tippers General GuidelinesStability All Models Operating Information Tire Pressure Weight Training Weight LimitationStability and Balance SAFETY/HANDLING of WheelchairsSafety/Handling of Wheelchairs Coping With Everyday Obstacles Reaching, Leaning and Bending Forward Reaching and Leaning BackwardsTipping Do not tip the wheelchair without assistanceMethod 1 Wheelchair With Step Tubes Method 2 Wheelchair Without Step TubesStairways Escalators Transferring To and From Other SeatsUnfolding and Folding Wheelchair UnfoldingFolding Wheelchair Do not allow upholstery to hang between the cross bracesInspect/Adjust Initially Safety INSPECTION/TROUBLESHOOTINGSafety Inspection Checklist Inspect/Adjust Weekly Inspect/Adjust MonthlyTroubleshooting Inspect/Adjust PeriodicallySuggested Maintenance Procedures MaintenanceMaintenance Safety Precautions Safety INSPECTION/TROUBLESHOOTING Installing/Removing Front Riggings InstallingFront Riggings RemovingBolt-In-Place Height Adjusting Footplate HeightSpring Button Height Fixed Frame Fixed FrameRaising/Lowering Elevating Legrest Assembly Installing Impact Guards/Calf StrapInstalling Impact Guards/Calf Strap Replacing Heel LoopFootrest shown Using ArmsRemoving/Installing Armrests ReplacingInstalling Armrest Removing ArmrestInstalling Back Canes Lightweight Wheelchair Only Seat and BackReplacing Seat Upholstery Adjusting Seat WidthReplacing Back Upholstery Pivot Link Seat and Back Standard Wheelchair with Fixed Frame Heavy Duty WheelchairsRemoving Lower Mounting Hardware Removing Upper Mounting HardwarePivot Link Seat and Back Removing/Installing Rear Wheels Rear WheelsReplacing/Repairing Rear Wheel Tire Replacing Rear Wheel HandrimFront Casters Installing/Replacing/Adjusting Front Casters and ForksInstalling/Replacing Front Casters and Forks Adjusting Forks Replacing Front CastersReplacing/Repairing Front Caster Tire/Tube Replacing Front CastersANTI-TIPPERS/WHEEL Locks Installing/Adjusting Anti-tippersInstalling Anti-Tippers Adjusting the Anti-Tippers Installing/Adjusting Anti-tippers- Anti-Tipper LengthUsing/Adjusting Disk Wheel Locks Using Patient Operated Disk Wheel LocksAdjusting Patient-Operated Wheel Locks Adjusting Patient-Operated Wheel LocksInstalling Wheel Lock Shoe Extensions Installing Wheel Lock Shoe ExtensionsSeat to Floor Changing Seat-to-Floor HeightHeight Mounting Position Standard and Heavy Duty/Extra Wide Wheelchairs Installing the Seat Positioning StrapOptions Lightweight Wheelchairs Options Options Limited Warranty Made in Mexico
Top Page Image Contents