Invacare Standard and Heavy Duty Wheelchairs, Lightweight manual Fixed Frame

SECTION 4—FRONT RIGGINGS

5.Adjust the footplate assembly height by aligning the desired adjustment holes in the upper front rigging support and lower footplate assembly.

6.From the outside of the swingaway front rigging, insert the threaded rivet through both the front rigging support and the footplate assembly.

7.From the inside of the swingaway front rigging, insert the button head screw through the appropriate adjustment hole and thread into the threaded rivet.

8.Using a screwdriver to hold the threaded rivet in position, securely tighten the button head screw. Torque to 32 in-lbs.

9.Rotate cam lock lever down to locked position.

10.Repeat STEPS 1-9 to adjust the remaining footrest.

	Front Rigging	Front Rigging
		Support			Threaded
	Support
					Rivet
		Button Head
		Screw
Button Head
Screw
Adjustment	Threaded Rivet
		Footplate
Hole
Cam Lock		Assembly	Adjustment		Footplate
Lever				Hole
					Assembly
Inside of
		Outside of
Swingaway		Swingaway		NOTE: Swingaway footrest shown.
Front Rigging		Front Rigging

FIGURE 4.3 Bolt-In-Place Height

Fixed Frame

NOTE: For this procedure, refer to FIGURE 4.4

1.Remove impact guards and/or calf strap, if necessary.

2.Loosen, but do not remove the bolt and locknut that secure the lower footrest assembly to the upper footrest support.

Wheelchair

Frame

3.Reposition the lower footrest assembly to the desired height.

4.Securely tighten the bolt and locknut.

5.Repeat this procedure for the other footrest, if necessary.

6.Replace impact guards and/or calf strap, if necessary.

Footplate

Assembly

Bolt and

Locknut

FIGURE 4.4 Fixed Frame

Part No. 1114811 33 Lightweight, Standard and Heavy Duty Wheelchairs