Invacare 1163141 Service Indicator Error Codes,  For the following table, refer to .1 on

Page 57

13 TROUBLESHOOTING

13.2Service Indicator Error Codes

For the following table, refer to FIGURE 6.1 on page 26.

FLASH

DESCRIPTION

SCOOTER STATUS

MEANING

1

Battery Low

Scooter continues to drive

The batteries are running low.

 

 

 

• Recharge the batteries.

2

Low Battery Fault

Scooter stops driving

The batteries have run out of charge.

 

 

 

• Recharge the batteries.

3

High Battery Fault

Scooter stops driving

Battery voltage is too high. This may occur if overcharged &/or traveling down a long slope.

 

 

 

• If traveling down a slope, reduce your speed to minimize the amount of regenerative charging.

 

 

 

• Turn the scooter off and on again.

 

 

 

• If the battery charger is connected, disconnect it from the scooter.

 

 

 

• Check the battery and associated connections and wiring.

4

Current Limit Time-

Scooter stops driving

The motor has been exceeding its maximum current rating for too long. This may be due to a faulty

 

out

 

motor.

 

 

 

• Check the motor and associated connections and wiring. Contact your Invacare dealer.

 

 

 

• Turn the scooter off, leave for a few minutes and turn back on again.

5

Park Brake Fault

Scooter stops driving

Either a park brake release switch is active or the park brake is faulty.

 

 

 

• Check the park brake and associated connections and wiring.

 

 

 

• Ensure any associated switches are in their correct positions.

 

 

 

• Contact your Invacare Dealer.

6

Throttle OONAPU

Scooter stops driving

The Throttle is out of neutral when turning the controller on.

 

 

 

• Ensure the throttle is in neutral when turning the controller on.

 

 

 

• The Throttle may require re-calibration. Contact your Invacare Dealer.

7

Speed Pot Fault

Scooter stops driving

The throttle, speed limit pot, SRW or their associated wiring may be faulty.

 

 

 

• Check the throttle and speed pot and associated connections and wiring. Contact your Invacare

 

 

 

Dealer.

8

Motor Voltage Fault

Scooter stops driving

The motor or its associated wiring is faulty.

 

 

 

• Check the motor and associated connections and wiring. Contact your Invacare Dealer.

9

Other error

Scooter stops driving

The controller may have an internal fault.

 

 

 

• Check all connections & wiring. Contact your Invacare Dealer.

10

Push/Rollaway Fault

Scooter stops driving

The scooter has exceeded the Push or Rollaway speed limits.

 

 

 

• Turn the scooter off and then on again.

Part No. 1163141

57

Invacare® Leo™ Scooter

Image 57
Contents Invacare Leo Contents Tiller Adjustment General SymbolsLimited Warranty General Guidelines SafetyOperation Information Setup DrivingTransport Stairways and Escalators Safety/Handling of Powered Scooters Repair or Service InformationSafety Safety Rain Test StorageBattery Weight TrainingElectrical and Grounding Disposal Weight LimitationEMI Information Electromagnetic Interference EMI From Radio Wave SourcesPowered Wheelchair Electromagnetic Interference EMI Safety Serial Number Label Product LabelingProduct Labeling Typical Product Parameters Overall Dimensions Technical DataSeat Dimensions Arm DimensionsWeight Inspection Safety Inspection ChecklistsInspect/Adjust Weekly Inspect/Adjust InitiallyInspect/Adjust Periodically Inspect/Adjust MonthlyBattery Charge Display Operating the Powered ScooterControl Panel Status DisplaySpeed Control Knob Right and Left Direction Indicator ButtonsHorn Button LightingControl Panel Operating the Scooter Operating the Powered Scooter Engaging/Disengaging the Brake Release Lever Detail a KEYEngaging/Disengaging the Brake Release Lever Pull Back to Engage Drive Push Forward to Disengage Push For this procedure, refer to Figure Activating/Deactivating the Audible SignalsLED Numbers Audible Signal Keystroke LIT Leds Condition CombinationInstalling Removing/Installing the SeatSeat and Arms RemovingRemoving/Installing the Seat Adjusting Seat Height Detail a TOP Shroud Adjusting 90 Seat Swivel Adjusting 90 Seat SwivelAdjusting the Arm Width Adjusting the Seat Position Forward/RearwardReplacing Armrest Pad Adjusting Armrest AngleDetail C Seat Positioning Seat Strap Installed Installing the Seat Positioning StrapAdjusting the Tiller Angle Tiller AdjustmentWheels and Casters Removing/Installing the Drive WheelsRemoving/Installing the Front Wheels Four Wheel Models Removing/Installing the Front Wheels Four Wheel Models Removing/Installing the Front Wheels Three Wheel ModelsRemoving/Installing the Front Wheels Three Wheel Models Batteries Recommended Battery Type Recommended Battery Type Orient the batteries as shown in Detail B of Figure Removing/Installing the BatteriesDetail a Preparing to Remove Batteries Charging the Batteries Detail a Transporting the Scooter TransportingDisassembling Rear Rear ScooterAssembling Suggested Maintenance Procedures MaintenanceGeneral Troubleshooting TroubleshootingIndicator Error Codes on  For the following table, refer to .1 on Service Indicator Error CodesInvacare Leo Scooter Invacare Leo Scooter USA