Invacare 1163141 user manual Assembling

Page 53

11 TRANSPORTING

Assembling

1.Unfold tiller. Refer to Adjusting the Tiller Angle on page 41.

2.Hold the seat post and align the curved brackets on the front frame assembly with the posts on the rear frame assembly.

3.While holding the seat post, slowly pivot the front frame assembly down until the release lever locks.

4.Ensure the release lever is locked and the front and rear frame assemblies are connected.

5.Connect the main wiring harness connector.

6.Install the batteries. Refer to Refer to Removing/Installing the Batteries on page 48.

7.Install the seat. Refer to Removing/Installing the Seat on page 33.

8.Install the basket.

Part No. 1163141

53

Invacare® Leo™ Scooter

Image 53

Contents Invacare Leo Contents Tiller Adjustment General SymbolsLimited Warranty General Guidelines SafetyTransport Operation Information SetupDriving Stairways and Escalators Safety/Handling of Powered Scooters Repair or Service InformationSafety Safety Rain Test StorageElectrical and Grounding BatteryWeight Training Disposal Weight LimitationEMI Information Electromagnetic Interference EMI From Radio Wave SourcesPowered Wheelchair Electromagnetic Interference EMI Safety Serial Number Label Product LabelingProduct Labeling Typical Product Parameters Overall Dimensions Technical DataSeat Dimensions Arm DimensionsWeight Inspection Safety Inspection ChecklistsInspect/Adjust Weekly Inspect/Adjust InitiallyInspect/Adjust Periodically Inspect/Adjust MonthlyBattery Charge Display Operating the Powered ScooterControl Panel Status DisplaySpeed Control Knob Right and Left Direction Indicator ButtonsHorn Button LightingControl Panel Operating the Scooter Operating the Powered Scooter Engaging/Disengaging the Brake Release Lever Detail a KEYEngaging/Disengaging the Brake Release Lever Pull Back to Engage Drive Push Forward to Disengage Push For this procedure, refer to Figure Activating/Deactivating the Audible SignalsLED Numbers Audible Signal Keystroke LIT Leds Condition CombinationInstalling Removing/Installing the SeatSeat and Arms RemovingRemoving/Installing the Seat Adjusting Seat Height Detail a TOP Shroud Adjusting 90 Seat Swivel Adjusting 90 Seat SwivelAdjusting the Arm Width Adjusting the Seat Position Forward/RearwardReplacing Armrest Pad Adjusting Armrest AngleDetail C Seat Positioning Seat Strap Installed Installing the Seat Positioning StrapAdjusting the Tiller Angle Tiller AdjustmentWheels and Casters Removing/Installing the Drive WheelsRemoving/Installing the Front Wheels Four Wheel Models Removing/Installing the Front Wheels Four Wheel Models Removing/Installing the Front Wheels Three Wheel ModelsRemoving/Installing the Front Wheels Three Wheel Models Batteries Recommended Battery Type Recommended Battery Type Orient the batteries as shown in Detail B of Figure Removing/Installing the BatteriesDetail a Preparing to Remove Batteries Charging the Batteries Detail a Transporting the Scooter TransportingDisassembling Rear Rear ScooterAssembling Suggested Maintenance Procedures MaintenanceGeneral Troubleshooting TroubleshootingIndicator Error Codes on  For the following table, refer to .1 on Service Indicator Error CodesInvacare Leo Scooter Invacare Leo Scooter USA