ATTACHING/ADJUSTING THE NECK SUPPORT (FIGURE 7)
Attaching the Neck Support
CURVED BACK.
1.Remove neck support bracket from packaging.
2.Unzip back cover on both sides of center panel.
3.Lift center panel.
NOTE: If a NEW neck support is used on an EXISTING Curved Back than the adapter plate and support bracket MUST be used.
NOTE: If a NEW neck support is used on a NEW Curved Back than the support bracket can be used WITHOUT the adapter plate.
4.Perform Steps 4a. and 4b. or 4c.:
a.Secure neck adapter plate to the back shell with the four (4) mounting screws provided (If applicable).
b.Then secure the neck support bracket to the neck adapter plate using the two (2) mounting screws provided.
c.Secure the vertical neck post to the back shell using the two (2) mounting screws provided.
5.Close center panel with the vertical neck post ex- posed through the slot provided in upholstery.
6.Zip the back cover closed.
7.Insert horizontal post into vertical post and secure with thumbscrew knob.
8.Insert vertical post into neck support bracket.
9.Secure with a thumbscrew knob or adjustable lever.
10.Insert detent pin into through both walls of vertical post (Transport Ready Option [TRRO]).
11.If adjustment is required, refer to ADJUSTING THE NECK SUPPORT in this instruction sheet.
ULTI-MATE AIR BACK.
NOTE: The standard attachment points are where the eyelets are located in the upholstery.
1.If there are no eyelets, pierce a hole pattern in the fabric, that resembles the pattern found on the neck support bracket. Ensure the pattern is aligned with the
NOTE: The cover may need to be removed to get a more precise location of the
NOTE: There is an extra set of
NOTE: If a NEW neck support is used on an EXISTING Curved Back than the adapter plate and support bracket MUST be used.
NOTE: If a NEW neck support is used on a NEW Curved Back than the support bracket can be used WITHOUT the adapter plate.
2.Secure neck adapter plate to the back shell with the four (4) long mounting screws provided.
3.Attach neck support bracket to the adapter plate using the two (2) short mounting screws provided.
4.Insert horizontal post into vertical post and secure with thumbscrew.
5.If adjustment is required, refer to ADJUSTING THE NECK SUPPORT in this instruction sheet.
Depth
Adjustment
Thumb-
screw
Knob
Vertical Post
Horizontal Post
Height
Neck Adjustment
AdapterStop
PlateHeight
Adjustment
Neck Support
Bracket
Thumbscrew Knob
NOTE: Only the curved back is shown for clarity. The neck support on the
NOTE: Ensure that the retaining screw is located in the end of the horizontal post.
Thumbscrew Knob
| Depth | |
| Adjustment | |
| Retaining | |
| Screw | |
| Height | |
Horizontal Post | Adjustment | |
Vertical Post | Stop | |
Height | ||
| ||
Neck Support | Adjustment | |
Bracket |
| |
Detent Pin | Adjustment Lever |
NOTE: Neck Adapter Plate NOT shown.
FIGURE 7 - ADJUSTING THE NECK SUPPORT
6