Chief Manufacturing CM2C40 installation instructions

Page 1

I N S T A L L A T I O N I N S T R U C T I O N S

Automated Flat Panel Ceiling Lift

This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio or television communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment to an outlet on a circuit other than that to which the receiver is connected Consult the dealer or and experienced radio/TV technician for help

CM2C40

Image 1
Contents CM2C40 Important Warnings and Cautions Installation Instructions CM2C40 Open-Ended Wrench Pre-Installation Configuration and Adjustments Power Requirements and WiringConfiguring the Mount for the Display Adjusting Faceplate LocationSevere Personal Injury or Damage to If more than 2 of faceplate adjustment is requiredCable Installation and Routing CM2C40 Installation Instructions Side Cover Mount Installation Display Installation CM2C40 Installation Instructions Bottom Cover Installation Bottom Cover Location Adjustment Lift Column Bearing Adjustment Remote Control Function Normal Operating ModeIR System Code IR-SE15 Control Codes IR-SE15 ProgrammingIR-SC33a Programming IR-SC33a Control Features Carrier Frequency 38KHzSystem Code 6E Serial Communications Connecctions to be made to 9 pin connector as followsError Message Table Motor Control Hardware Information CM2C40 Hardware ReferenceCM2C40 Connectors and Switches Dry Contact Closures CM2C40 Interface Board Hardware InformationVoltage Sense External Power Source Extend Retract with Single SwitchVoltage Sense Internal 24V DC Power Source Extend Error InputExtend Limit Option Retract Error InputRetract Limit Option SW1 Connector and Switch AssignmentsCeiling Mounting Holes Door Bracket Troubleshooting +86-755-8996 +86-755-8996 9226 8996 9236 8996