Chief Manufacturing CM2C40 installation instructions Cable Installation and Routing

Page 7

Installation Instructions

 

CM2C40

15. Align studs in faceplate with appropriate holes in faceplate

 

mounting bracket and hang faceplate on bracket with studs.

 

16. Secure faceplate to faceplate mounting bracket using two

 

locknuts. (See figure 7)

 

 

 

 

1

 

 

x2

16

x2

 

Figure 7

 

 

Cable Installation and Routing

 

 

The CM2C40 has an integrated cable management system that

 

allows cables to be automatically "fed out" as the lift raises, and

Cable Guide

"reeled in" as the lift lowers while maintaining constant cable

tension.

 

Side Cover

NOTE: Some components have been removed for clarity in

 

the artwork associated with this procedure.

IMPORTANT ! : The CM2C40C40 requires minimum cable lengths of 8 feet from display through lower mount.

Figure 8

3.Slide cable guide side cover away from mount and carefully set aside.

To install cables:

1.Remove two screws securing cable guide side cover.

2.Set screws aside for reuse. (See figure 8)

Cable Guide

Side Cover

3

Figure 9

4.Loosen six cable clamps. (See figure 10)

5.Route cable(s) down through upper cable clamp. (See figure 10) and (See figure 11)

IMPORTANT ! : Leave enough cable length available above upper cable clamp to allow the routing and tie-down of cables between upper cable clamp and display.

7

Image 7
Contents CM2C40 Important Warnings and Cautions Installation Instructions CM2C40 Open-Ended Wrench Adjusting Faceplate Location Power Requirements and WiringPre-Installation Configuration and Adjustments Configuring the Mount for the DisplaySevere Personal Injury or Damage to If more than 2 of faceplate adjustment is requiredCable Installation and Routing CM2C40 Installation Instructions Side Cover Mount Installation Display Installation CM2C40 Installation Instructions Bottom Cover Installation Bottom Cover Location Adjustment Lift Column Bearing Adjustment Remote Control Function Normal Operating ModeIR System Code IR-SE15 Control Codes IR-SE15 ProgrammingIR-SC33a Programming IR-SC33a Control Features Carrier Frequency 38KHzSystem Code 6E Serial Communications Connecctions to be made to 9 pin connector as followsError Message Table Motor Control Hardware Information CM2C40 Hardware ReferenceCM2C40 Connectors and Switches Dry Contact Closures CM2C40 Interface Board Hardware InformationExtend Error Input Extend Retract with Single SwitchVoltage Sense External Power Source Voltage Sense Internal 24V DC Power SourceExtend Limit Option Retract Error InputRetract Limit Option SW1 Connector and Switch AssignmentsCeiling Mounting Holes Door Bracket Troubleshooting +86-755-8996 +86-755-8996 9226 8996 9236 8996