CM2C40 | Installation Instructions |
NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See figure 19)
Remove pin | 1 | |
and nuts and | ||
| ||
move to lower holes. |
|
2
A padlock or bolt may be placed through latch holes
Figure 19
4.Loosen four nuts securing right and left hand bottom cover adjustment brackets to faceplate mounting bracket.
(See figure 20)
5.Slide bottom cover adjustment brackets upward or downward until lip on bracket is positioned 1/4" below the bottom of display. (See figure 21)
6.Tighten four nuts to secure bracket in position. (See figure 20)
WARNING: IMPROPER INSTALLATION CAN LEAD TO SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Make sure all four nuts are tight before continuing installation!
Display removed |
|
for clarity |
|
3 | 5 |
X4 |
|
Figure 20
Display
| 4 |
Bottom Cover |
|
Mounting Bracket | 1/4" minimum |
Bottom Cover Mounting Bracket
Figure 21
12