Chief Manufacturing CM2C40 installation instructions Display Installation

Page 11

Installation Instructions

CM2C40

7.While maintaining dimensions referenced in figure 15, mark base plate mounting hole locations. (See figure 16)

8.Drill pilot holes at marked locations.

9.Mark four side bracket mounting hole locations if applicable. (See figure 16)

10.Drill four pilot holes at marked locations.

11.Secure base plate to structure using either two (wall mount)

or six (ceiling mount) 5/16" flat washers and two or six six

5/16" x 2 1/2" lag screws.

(See figure 16)

12.Secure side brackets, if applicable, to studs using four 5/16" flat washers and four 5/16" x 2 1/2" lag screws.

(See figure 16)

 

X6

8

9

 

12

12

 

 

10

 

X4

 

X4

 

11

 

13

Figure 16

13. Connect mount power cord to outlet.

Figure 17

Display Installation

WARNING: EXCEEDING MAXIMUM WEIGHT CAPACITY CAN LEAD TO SERIOUS PERSONAL INJURY OR AMAGE TO EQUIPMENT! It is the installers responsability to ensure the total amount of weight placed on the mount does not exceed 190lbs (86.18 kg) the maximum capaity of the CM2C40.

WARNING: PINCH HAZARD! FINGERS OR HANDS BETWEEN MOVING PARTS CAN LEAD TO SEVERE PERSONAL INJURY! Keep fingers and hands away from mount when operating.

WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Displays can weigh in excess of 40 lbs (18.1kg). ALWAYS use two people and proper lifting techniques when installing display.

WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make sure mounting buttons on display are properly seated in mounting holes in faceplate.

To install display:

1.Lower lift using the remote control provided.

2.While supporting both sides of display, align four mounting buttons on display or interface bracket with four mounting holes in faceplate. (See figure 18) and (See figure 19)

3.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes and "click lock" mechanism has engaged. (See figure 18) and

(See figure 19)

1

 

3

1

2

 

Figure 18:

11

Image 11
Contents CM2C40 Important Warnings and Cautions Installation Instructions CM2C40 Open-Ended Wrench Adjusting Faceplate Location Power Requirements and WiringPre-Installation Configuration and Adjustments Configuring the Mount for the DisplaySevere Personal Injury or Damage to If more than 2 of faceplate adjustment is requiredCable Installation and Routing CM2C40 Installation Instructions Side Cover Mount Installation Display Installation CM2C40 Installation Instructions Bottom Cover Installation Bottom Cover Location Adjustment Lift Column Bearing Adjustment Remote Control Function Normal Operating ModeIR System Code IR-SE15 Control Codes IR-SE15 ProgrammingSystem Code 6E IR-SC33a Control Features Carrier Frequency 38KHzIR-SC33a Programming Serial Communications Connecctions to be made to 9 pin connector as followsError Message Table Motor Control Hardware Information CM2C40 Hardware ReferenceCM2C40 Connectors and Switches Dry Contact Closures CM2C40 Interface Board Hardware InformationExtend Error Input Extend Retract with Single SwitchVoltage Sense External Power Source Voltage Sense Internal 24V DC Power SourceRetract Limit Option Retract Error InputExtend Limit Option SW1 Connector and Switch AssignmentsCeiling Mounting Holes Door Bracket Troubleshooting +86-755-8996 +86-755-8996 9226 8996 9236 8996