Emerson IM-106-4050 instruction manual Section Setup, Overview

Instruction Manual

IM-106-4050 Original Issue March 2006

OxyBalance Oxygen Display and Averaging System

Section 3 Setup

Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-1

Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-1

Before starting to install this equipment, read the "Safety Instructions" in Appendix A: Safety

Data. Failure to follow the safety instructions could result in serious injury or death.

	Disconnect all power before installing or replacing components. Failure to disconnect power
	may result in electrical shock and/or damage to the equipment.
OVERVIEW
	This section provides information on setup and configuration of the
	OxyBalance Oxygen Display and Averaging System
SETUP	Each O2 probe generates a 4-20 mA output signal that is received by the
	OxyBalance system. When a probe channel detects a current signal greater
	than 3.5 mA, that probe is considered active, and is automatically made
	available. It is not necessary to tell the OxyBalance that a probe is present. It
	is automatically detected and used. Table 3-1shows how the OxyBalance
	system interprets and displays these signals.

Table 3-1. Signal Interpretation

4-20 mA Signal Value	Status	Display Color
<3.5 mA	Probe Inactive	Not Shown
3.5 mA to 3.6 mA	Probe Failed	Red
3.6 mA to 3.8 mA	Reading Under Range	Yellow
3.8 mA to 20.5 mA	Good Reading	Green
20.5 mA to 21 mA	Reading Over Range	Yellow
>21 mA	Probe Failed	Red

After these signals are converted into an O2 % they are displayed on the touch screen interface. The rest of this section will outline the necessary steps to configure and operate the OxyBalance system through the touch screen interface.

http://www.processanalytic.com