Evolution Technologies OM-900M manual Monitoring Battery Energy Level, Installing the System

Page 14

ASSEMBLY AND USE

MONITORING BATTERY ENERGY LEVEL:

The EVOLUTIONTM MOTION conserver is equipped with a low battery indicator light that alerts you when a battery change is needed.. The following signal will be displayed as your batteries

become depleted: Blinking red light – Low battery energy level.. Replace batteries..

Disposal of Batteries: Do not dispose of used batteries in the household waste.. Contact a public waste disposal authority for proper disposal instructions..

INSTALLING THE SYSTEM:

STEP 1: Loosen the cylinder adjustment handle..

STEP 2: Lower the EVOLUTIONTM MOTION conserver over any CGA 870 post-valve cylinder with the alignment pins toward the holes on the cylinder neck [Fig.. F]..

STEP 3: Align the two (2) pins and seal washer with the corresponding holes on the cylinder post valve..

STEP 4: While holding the unit in place, tighten the cylinder adjustment handle by turning clockwise [Fig.. F]..

* NOTE: Tighten only by hand. The use of a tool to tighten the handle may damage the unit.

FIGURE F

Attaching the EVOLUTIONTM

MOTION conserver to the cylinder

CAUTION! If you are unable to eliminate leaks by manually tightening the

cylinder adjustment handle, replace the seal washer.. If leaks persist, the unit must be returned for service..

STEP 5: Attach a standard cannula to the oxygen supply outlet.. See page 14 for an illustration demonstrating the proper positioning of the nasal cannula..

13

Page 13 Page 15
Image 14
Page 13 Page 15
Contents OM-900M Table of Contents Care and Maintenance Hygienic Preparation Intervals General Information Figure aImportant Safety Rules & Precautions Operating the UnitImportant Safety Rules & PRECAUTIONS Please remember that this is for your own safetyACCESSORIES/REPAIRS User Qualification IntroductionPurpose Function Description of Parts & Controls Evolution TM Motion ConserverDescription of Parts & Controls Assembly and USE NON-PORTABLE USEInstalling Alkaline Batteries Figure E1Monitoring Battery Energy Level Installing the SystemOperating Instructions Fig.. G Proper Positioning Nasal CannulaOperating Instructions Setting Oxygen Cylinder DurationIntervals Care and MaintenanceHygienic Preparation Procedure Patient ChangeFunctional Check Checking for Leaks DisposalStandard Product PRODUCTS, Spare PARTS, AccessoriesAccessories Spare PartsTroubleshooting Guide Problem Probable Cause SolutionTo a user’s activity.. As a result, the device may interpret Classifications and Specifications SpecificationsSpecifications Classifications and Specifications Separation Distances Symbols KEY Symbol Meaning Type PlateLimited Warranty Important Information to Record Page EC REP
Top Page Image Contents