INSTALLATION
Please use the strain relief mechanism as displayed. This provides extra protection for the cable at the connection point. It will extend the life of the power cable and reinforce the connection to the equipment.
The loopHEARTM will need to charge for 4 hours before its first use. The power indicator will blink red whilst the battery is charging. When the power indicator is blinking green, the battery is fully charged.
Locating the loopHEAR TM
In order to receive the optimal sound from the loopHEARTM, the ideal location is facing the user. There are two options when locating the loopHEARTM.
Fully Portable
The loopHEARTM can be used as a fully portable unit with or without the base plate attached. It can be used in a variety of locations with no setup required and can be used immediately.
Semi Fixed
If you want to ensure the loopHEARTM stays in one place then it can be used as a semi fixed unit as follows:
1)Choose the location to fix the loopHEARTM. Please bear in mind the range of coverage available (see below). Ensure you make full use of it
2)Remove the base plate – as described in Battery Charging above
3)Screw the base plate to the table or desktop with the screws provided
4)Replace the base plate – as described in Battery Charging above
LH100
1m
60°
9
USING THE loopHEARTM
Turn the loopHEARTM On
Turn the power switch found at the rear of the unit to the I position. The power indicator lights up (solid green if the power adaptor is not plugged in, blinking green if it is plugged in).
When the battery is weak, the indicator will light up red (solid red if the power adaptor is not plugged in, blinking if it is plugged in).
Plug in the power adaptor to recharge the battery.
Turn the loopHEARTM Off
After use, turn off by setting the power switch at the back of the unit to the
0position.
Using the Headset
A headset is supplied for hearing impaired users who do not use a hearing aid or do not have a ‘T’ switch on their hearing aid. Simply, plug the headset into the HEADSET jack (3.5mm), found at the rear of the loopHEARTM unit. The volume can be adjusted by using the volume knob also found at the rear of the unit (turn knob clockwise to increase volume).
Using the External Microphone
Plug the supplied microphone into the MIC JACK at the back of unit. The external microphone will now override the
The external microphone has a clip. This is extremely useful for attaching to your lapel as illustrated. The external microphone can also be wall mounted with the wall clip supplied.
10