Installation Plug ‘N Play Function Devices

INSTALLATION (PLUG ‘N PLAY FUNCTION DEVICES)

You can purchase the specified Plug ‘N Play devices that are explained on page 6-7 and install them in positions , 2 and 3 . Position can only be used with Multi-Speed module (model FV-05-11VKSL1 already have

this control installed), position 2 and 3 can be used for any of the other optional control modules.

1.Remove the connector cover from position , 2 or 3 .

2.Plug in the specified devices to Base PCB box and fix to the slot, till hear the sound installed in place.

Connector	Base PCB box
cover	Base PCB box	Slot
		Slot

2		2
2	3	3
		3

Clasp

Squeeze tabs on the Clasp to remove. Squeeze, insert and release the tabs on Clasp to replace.

INSTALLATION (NEW CONSTRUCTION)

The fan position between joists from 16" to 24" on center can be adjusted flexibly.

CAUTION

Machine screw (M4X6)

Adaptor

Please wear gloves during the installation work as follow.

1.Disconnet plug connector from receptacle and remove adaptor from fan body by removing the machine screw (M4X6) before installation. (Fig.1)

IMPORTANT:

Remove the tape from damper and adaptor before installation. As shown below:

Adaptor

Damper

Tape

2.Bend down 4 tabs for positioning, install the Flex-Z FastTM bracket to joists by using 2 tapping screws (ST4.2X20) (Please prepare the screws and put on Flex-Z FastTM bracket before Flex-Z FastTM bracket is installed on joist). (Fig.2)

3.Adjust the length of Flex-Z FastTM bracket as the spacing between joists, and install to joists by using 2 tapping screws (ST4.2X20). (Fig.3)

4.Remove junction box cover and secure conduit or stress relief to junction box knock-out hole. (Fig.4)

5.Install a circular duct and secure it with clamps,

or ties and seal it with mastic or approved foil tape. 4 inch 6 inch circular duct is needed to connect to relevant part of common adaptor. (Fig.4)

6.Install the adaptor to Flex-Z FastTM bracket by using 2 self-drilling screws. (Fig.4)

Fan body

Fig.1

Joist

	Bend down
	4 tabs
2 Tapping screws	Fig.2
(ST4.2X20)
Joist

	2 Tapping screws	Fig.3
	(ST4.2X20)	Fig.3
	(ST4.2X20)

	Circular duct
Conduit	Mastic or
	approved
	foil tape
Knock-out
hole
Junction box
cover	2 Self-drilling screws
	2 Self-drilling screws
	Fig.4