Hague Quality Water Intl 63MAQ, 63BEQ warranty Let is not controlled by a switch

Troubleshooting

Problem	Cause	Solution
Flow indicator blinks when water	There is a leak in your household	Repair the leak.
is not being used. (Fig. 2)	plumbing system.
No read-out in display.	Electric cord is unplugged.	Plug in transformer.	(Fig. 1.)
	No electric power at outlet.	Check power source. Make sure out-
		let is not controlled by a switch.
	Defective transformer (fig. 3).	Test with volt meter for 12 VAC at
		control. If less than 10 VAC or
		greater than 14 VAC, replace trans-
		former.
	Defective circuit board.	With 12 V AC present at control,
		replace computer control.
	High ambient temperature. If tem-	See Enginerring Specifications,
	perature exceeds 120°F, display will	page 13.
	blank out. This does not affect the
	operation of the controller.
Appliance stays in regeneration.	Defective magnet disk.	Replace magnet disk. (See Fig. 8)
C4cle display remains "going to
	Foreign object in valve body.	Remove foreign objects from valve
		body. (See Fig. 5)
	Broken valve assembly. Motor running.	Repair drive end cap. (See Fig. 8)
	Magnet disk not turning.
Excess water in brine tank.	Restricted, frozen or pinched drain line.	Remove restriction, thaw or straighten
	(See Fig. 1)	drain line..
	Plugged brine line, brine line flow	Clean flow control, air check and
	control or air check (See Fig. 9)	brine line. (See Fig. 12)
	Plugged injector assembly.	Clean or replace injector assembly.
	(See Fig. 6)	Replace throat if removed.
	Sticking brine refill valve. (See Fig. 9)	Remove brine valve. Lubricate piston
		with silicone grease and reassemble.
Not regenerating in proper sequence.	Defective magnet disk.	Replace magnet disk. (See Fig. 8)
	Defective controller.	Replace controller.	(See Fig. 3)

18