Parts Drain End Cap Assembly | Hague Quality Water Intl 63MAQ

Parts - Figure 11 - Drain End Cap Assembly

ITEM NO.	QTY.	PART NO.	DESCRIPTION
1	1	93808	O-Rinq
2	1	90268	Drain End Cap
3	1	H2086-3.0	Drain Line Flow Control
4	1	90267	Retainer

(1)90268 Drain End Cap: Seals the left opening on the Main Valve Body. The opening is sealed with an 0-ring used as axial or "face" seal. The 0-ring sits in a groove in the End Cap. This groove must be free of defects such as pits or scratches and also free of debris. When assembling the End Cap to the Valve Body, care should be taken to make sure that the 0-ring stays in the groove in the End Cap. If misaligned, the 0-ring can become pinched and leak.

(2)H2086 Drain Line Flow Control Button: The Drain Line Flow Control Button (D.L.F.C.) maintains a constant (plus or minus 10%) backwash flow rate at varying pressures. Care should be taken when replacing FCB

Specifications, pg. 13. The flow control button should be assembled with the lettering facing the retainer.

H2086 - 2.4

H2086 - 3.0

H2086 - 5.0

H2086 - 7.0

(3)90267 Retainer: The Retainer holds the backwash Flow Control Button in place. One side is smooth and the other has a groove for a screw driver. When assembling the retainer to the Drain End Cap, the retainer should be "screwed" in until it stops. If the retainer is not fully engaged, the Flow Control may not function properly.

(4)93808 End Cap 0-ring

90614 Drain End Cap Assembly (contains all of the above items)