Specifications

How to remove the built-in rechargeable batteries before disposal of the shaver

(see fig. 11)

The batteries in this shaver are not intended to be replaced by consum- ers. However, the batteries may be replaced at an authorized service center. The procedure described be- low is intended only for removal of the rechargeable batteries for the purpose of proper disposal.

1.Remove the screw (a) and the bottom cover (b).

2.Slide the trimmer handle up until it clicks in.

3.Remove the screw (c) and the panel cover (d).

4.Remove the six screws (e).

5.Remove the back panel (f).

6.Lift the battery block (g) and re- move it from the battery terminal sealing (h).

7.Remove the batteries from the battery block (g).

WARNING:

Do not attempt to replace the bat- teries for the purpose of reusing the shaver. This could result in the risk of fire or electric shock.

Caution – To prevent personal injury or damage to the product,

• Do not charge the shaver where the

temperature is below 5°C (41°F) or

above 35°C (95°F), where it will be

exposed to direct sunlight or a heat

source, or where there is a lot of

moisture.

• Use only the included adaptor

RE7-05 to charge the ES8151/

ES8152 shaver.

• Dry the shaver completely before

charging it.

• Keep the adaptor away from water

and handle it only with dry hands.

• The charge status lamp may not

glow for several minutes after

charging has commenced but will

glow if charging is continued.

• Grip the adaptor when disconnect-

ing it from an AC outlet; tugging on

the power cord may damage it.

• Store the adaptor in a dry area

where it will be protected from dam-

age.

• Do not pull, twist, or severely bend

the power cord.

• Do not wrap the power cord tightly

around the appliance.

• The linear motor of the shaver may

start operating without the On/Off

switch on if the shaver is placed

near a television, stereo, audio-

visual equipment or anything that

generates strong magnetic field.

that are designed for toilets, bath- rooms or kitchen appliances. Do not submerge the shaver for a long time.

•Do not wipe any part of the shaver with thinner, benzine or alcohol. Clean it by using a cloth dampened with soapy water.

•Do not take the housing apart as this can affect the watertight con- struction.

•Do not clean with water when the shaver is connected to the power cord.

•Do not shave when the “sonic” vi- bration is activated, as it may dam- age your skin.

•When cleaning the shaver with water, do so with both the inner blades attached. (Doing so with only one of the inner blades at- tached makes an abnormal noise and may damage the shaver.)

Power source: 100-240V AC,

50-60 Hz (Automatic voltage conver- sion)

Motor voltage: 2.4 V DC

Charging time: 1 Hour

This product is intended for house- hold use only.

Do not place the shaver near these

equipments.

• Wash the shaver in tap water. Do

not use salt water or boiling water.

10Also, do not use cleaning products

FORYOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT 1-800-338-0552.

FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES MENTIONED ON THE BACK PAGE.