MAINTENANCE and LUBRICATION
|
|
| Cable at pulley and hinge areas | Clean and lubricate. Apply Light Oil - See |
| continued |
| ||
|
|
|
| Lubrication Diagram |
|
|
| Drive arm slot | Apply |
|
|
| Inspect drive arm pivot points (mounting | Tighten, replace or correct as needed. |
| 8 Weeks | screws, nuts and bearings) for positive secure- |
| |
| ment, wear or damage |
| ||
| or 200 |
| ||
|
|
| ||
| Cycles | Inspect drive arm slots for excessive wear or | Correct as needed | |
|
|
| damage |
|
|
|
| Clean ramp and ramp mounting area (ensure | Clean and remove debris or obstructions |
|
|
| no debris in area to obstruct stowing/stacking) |
|
|
|
| Cycle ramp and observe drift speed during | ,IGULIWVWRRIDVWDGMXVWDSSOLFDEOH'ULIW0LFUR- |
|
|
| deploy and stow functions | switch Cam so drift begins at reduced height. |
|
|
| Inspect ramp for wear, damage or any abnor- | Correct as needed |
|
|
| mal condition. |
|
|
|
|
|
|
1 Year
or
1250
Cycles
Perform all procedures listed in previous section also
5HPRYHVXEÁRRUSDQFRYHUDQGFOHDQGLUW | Blow out with air compressor |
and other foreign debris |
|
5HPRYHVXEÁRRUSDQFRYHUDQGOXEULFDWH | Clean and lubricate. Apply |
drive arm gear and cylinder gear rack |
|
5HPRYHVXEÁRRUSDQFRYHUDQGLQVSHFW |
|
• Pump mounting bolts for securement (loose | 5HVHFXUHDGMXVWPLFURVZLWFKHVUHSODFHGDP- |
or missing) | aged parts or otherwise correct as needed. |
•Drive arm and gear rack weldment teeth
IRUIRUHLJQREMHFWVZHDURUGDPDJHEHQW deformed, misaligned), positive securement and proper operation
•Gear rack weldment pin securement
+\GUDXOLFF\OLQGHUKRVHVÀWWLQJVDQGFRQ- nections for wear, damage or leaks
•Harness cables, wires, terminals and con- nections for securement or damage
•Relays for securement or damage
•Microswitches and cams for securement and
DGMXVWPHQW
•Microswitch wires and terminals for secure- ment or damage
Page 22