9.
When Replacing Cartridge
12 |
13 |
1Slide back cover off razor. Remove empty cartridge from razor cover and pull out the connector. Insert the connector into a new cartridge.The connector is secured when you hear it click into place.
2Rinse out razor cartridge compartment with hot water. Shake off excess water and slide new cartridge with connector into the Razor. Close back cover.
When Replacing Cartridge or Once Every Month
For consistently close and comfortable shaves, razor heads should be cleaned in a degreasing liquid or alcohol and then lubricated.
IMPORTANT: Do NOT interchange the cutters and combs.They are a matched set and if inter- changed may adversely affect shaving performance until cutters reseat themselves.Therefore, remove, clean and replace each set individually.
1Switch Razor OFF.
2Press the Razor Head Release Button located under razor heads on front side of Razor.
3Remove the Razor Head Assembly and clean the razor heads and hair chamber by running under hot water. Be sure water is not too hot so as to cause burns or scalding.
4While holding Razor Head Assembly in one hand, press center wheel down while turning counterclockwise to release and lift out frame. Set frame aside (Fig. 12).
5Remove one cutter/comb, at a time, out of frame (Fig. 13).